12864 在51单片机中的程序，用点阵模块改个数组就可以变成自己的了...

ＣＡＮ协议标准设计规范（电梯项目080716）.docＣＡＮ协议标准设计规范（电梯项目080716）.doc-CAN protocol standard design specifications (elevator project 080716). DocCAN protocol standard design specifications (elevator project 080716). Doc

SM5964在系统编程的源代码,通过COMM串行口进行程序下载,方便嵌入式系统开发-programming specification of the system"s source code through COMM serial port for downloading procedures, facilitate embedded system development

AVR单片机M16L绝对可以用的4*4键盘程序,附连接图.-AVR Singlechip M16L can definitely use 4* 4 keyboard procedures, attached connection diagram.

精度为20位的数模转换芯片CS5503数据手册，有需要的朋友可以下来-Low-Cost, 16 & 20-Bit Measurement A/D Converter

LT_1B msp430开发板例子程序－TA_15

51单片机控制18B20传感器，利用液晶显示也可以利用数码管显示-51 Singlechip 18B20 control sensors, the use of liquid crystal display can also use digital tube display

基于单片机技术的声反馈抑制系统研究 学术论文-Single-chip technology based on acoustic feedback suppression system for academic papers

红外线遥控音量电位器,红外线遥控音量电位器-Infrared remote control volume potentiometers, infrared remote control volume potentiometer

AVR单片机入门及C语言高效设计实践(13)源程序码-AVR单片机入门及C语言高效设计实践13)源程序码

本程序是通过单片机进行电机的控制，可以控制电机的转速，前进和倒退。单片机通过串口接收来计算机的控制信号(可以采用无线方式进行串口的通讯)。工具采用的是“韦福”的仿真软件。-this procedure through the MCU for motor control, control of the motor forward and retrogression. SCM through the computer serial port to receive the control signal (which can be used for wireless serial communications). Tools used the "ru" simulation software.