一个关于液晶的单片机例程，和液晶的资料，很有启发意义的。做液晶时可供参考。...

12864串口液晶,包含两个文件:lcd.c与lcd.h. 调用 void printLCD(uint8 x,uint8 y,uint8 *fmt, ... ),即可将显示的字符串发送到液晶屏显示-12864 Serial LCD, contains two documents: lcd.c with lcd.h. call void printLCD (uint8 x, uint8 y, uint8* fmt, ...), can be shown in the string sent to the LCD screen display

Cygnal的F020采集电压信号送到液晶显示程序，经测试可用。-Cygnal

本程序为应用在Arm7下的Ps2键盘接口程序。避免了因多中断而数据出现错误的情况-This procedure is used in ARM7 under the Ps2 keyboard interface program. To avoid interruption caused by more than the case of data error

用msp430 对128×64的LCD的完全操作， -Controller with 128 64 LCD full operation,

这篇程序是我一个同学编的,并且已经应用到了二相步进电机(四线步进电机)上了.但是我认为此程序需要改进的地方有很多. -This procedure is a fellow student, I made and have been applied to a two-phase stepper motor (four-wire stepper motor) on. But I think this process needs to be improved where there are many.

此C语言程序实现串行接口电压输出型D/A转换器MX532的控制。-This C language program serial interface voltage output type D/A converter MX532 control.

ucos的PPT课件 基本原理及其在9s12单片机上怎样移植-OUT PPT Courseware the basic principle and the 9s12 on how to transplant MCU

这是一段简单的8位数码管驱动程序，解决单片机菜鸟们的单片机入门苦恼，纯源码-This is a simple 8-bit digital tube driver to resolve the single-chip microcontroller菜鸟们entry distress, pure source

本程序用于接收一般的红外线代码。很适合51单片机的新手学习。-This procedure is used to receive infrared codes in general. Very suitable for the novice to learn microcontroller 51.

QG8_demo学习板开发板例程 ｉ２ｃ的例程，辛苦找来。 经过验证是正确的。-Board development board QG8_demo learning routines i2c routine, it is tough to get a large. Verified to be correct.