本程序实现的是液晶显示

用MSP430开发工具闹钟

该程序允许具有引导加载程序功能的AVR读取/写入自己的Flash/EEprom。要进入编程模式，计算应用程序，如果不正确，则进入编程模式。否则，将从应用程序区域中的$0000“重置”向量执行正常执行。

自动升降电梯控制器设计 要求： 设计一个6层楼的电梯控制器。 该控制器可控制电梯完成6层楼的载客服而且遵循方向优先原则，并能响应提前关门延时关门，并具有超载报警和故障报警； 同时指示电梯运行情况和电梯内外请求信息。-Auto-Lift elevator controller design requirements: design of a six-story elevator controller. The controller can control the completion of six-story elevator containing the principle of giving priority customer service, and follow the directions, and can respond to close ahead of schedule delay closing, and has overload alarm and fault alarm also instructed the elevator and elevator operation request information both inside and outside.

24C04为基础的51单片机仿真I2C总线的程序，适用于初学者参考-24C04-based microcontroller simulation of I2C Bus 51 procedures for advanced users

MDK学习之，TIM学习M DK学习之，TIM学习-MDK learning, TIM learning M DK Learning, TIM learning

指南描述了一组用于SPI协议软件实现的低级程序，在主模式中所有的通信都来自AVR-guide describes a group SPI protocol software for the realization of the low-level procedures, the main mode of communication are all from the AVR

linux系统下的luvcview的摄像头驱动程序。可在ARM板子上和PC上运行，有两个makefile 文件。对luvcview的程序添加了截图功能，所得图片保存在文件目录下。

c51programe的程序可能有你想要的

wince操作系统下USB设备的驱动程序源码-wince operating system USB device driver source code

精品资料-嵌入式系统经典教材 系统讲解了嵌入式开发-Quality information- the classic embedded system teaching system on the embedded development