大三时做的，效果不错，可以做到10米，精度10cm以内，看看知道了...

此项目是一个简单的例子，关于如何收集温度和湿度传感器 DHT11，和我们也传输的温度和湿度对无线传感器网络与 MSP430G2553 MCU 的 PC。您可以修改我意识到，在 12684LCD 上显示的温度和湿度的程序。该项目建成使用 IAR 工具。希望你能意识到它。

AT80x52.h源程序注释，本人亲自注释-Notes AT80x52.h source, I personally Notes

本文适用于对嵌入式系统没有概念和经验， 渴望进入嵌入式系统开发的领域， 但又觉得系统太复杂，要学的东西太多， 感觉完全无从学起，无从下手 的 初级开发人员-this applies to the concept of embedded systems and no experience, eager to enter the embedded system development areas, but think the system is too complicated, to learn so many things, not feeling completely started learning the way of the primary developers

浙江大学的悟空嵌入式系统模拟器的安装程序及使用说明。WUKONG是从底层的CPU、硬件电路板开始模拟的开放源码的嵌入式系统模拟器。-Zhejiang University Wukong Embedded System Simulator installation procedures and use. WUKONG from the bottom of the CPU, hardware circuit board simulation of the beginning of open-source embedded system simulator.

能将ELF /AFX 文件转换成二进制文件的解析源码-can ELF/AFX convert documents into the binary files of source code analysis

电机的控制端分别接P1.7,P2.0,P2.1,P2.2,调速端接P2.3,P2.4,通过msp430f149的P2.3,P2.4输出PWM波，实现对电机的控制.

serial port driver in linux

1．在发送端通过一个编码系统对待传数据预先编码，在接收端将传来的数据进行译码（复原）。对于双工信道（即可以双向传输信息的通道），每端都需要一个完整的编/译 码系统。 2．本程序的目的是大大提高通信的信道利用率，缩短信息传输时间，降低传输成本。 -1. In the transmitter through a coding system for pre-treatment data-coding the receiving end of data from the decoding (recovery). For dual-channel (two-way transmission of information can access), each side needs a complete encoding/decoding system. 2. The procedures are designed to greatly enhance the communication channel utilization, reduced transmission time, and lower transmission costs.

很好的一个嵌入式linux平台下的bootloader，主要适用于mips体系结构，适合嵌入式linux的学习和项目开发。-a good embedded Linux platform under the Bootloader primarily to the MIPS architecture for embedded linux learning and project development.

将CAN现场总线移植到UCOS2中的驱动程序，在BC中调试运行成功-CAN fieldbus will be transplanted to UCOS2 the driver, were in BC successful operation Debugging