51单片机串口通信汇编语言源代码，发送端和接收端的

此文件是LCM12864在LPC2131上的驱动代码-This file is in LCM12864 driver code on the LPC2131

一个小型的数控电源的源码，采用DAC0832进行转换，实现0-12V的精度为0.1的步进调压。-NC a small power source, using the conversion DAC0832, 0-12V realize the accuracy of the stepper regulator 0.1.

这是基于89C51单片机的实用热水器监视器源程序，程序由汇编语言编写-This is based on the 89C51 of usable water heater monitors source, procedures prepared by the assembly language

ATT7022B与C8051F的通讯licheng-C8051F communication with ATT7022B Licheng

是用ATmega162单片机控制1602LCD液晶显示的C语言源代码，包括了显示一个字符或一个字符串的功能-ATmega162 microcontroller is used to control 1602LCD LCD C language source code, including a show or a character string function

使用ATMEGA8L单片机做的两线串行接口TWI的功能，即I2C的功能！-Singlechip ATMEGA8L make use of two-wire serial interface TWI function, that is, the functions of I2C!

本设计以P89V51RD2FN单片机为电动小车的控制核心，采用MSA-LD2.0倾角传感器实时测量跷跷板的倾斜角，用ST198光电传感器检测黑色引导线监测小车运动。光电传感器和倾角传感器模块把实时测量信号馈送至单片机，利用专用细分芯片TA8435H驱动步进电机，以脉宽调制式斩波方式对步进电机步进角进行细分，控制和调节小车速度。采用增量式PID控制算法确保小车能够达到平衡；用RT128×64M液晶显示时间、角度等参数。经测试表明：小车各项性能指标达到设计要求，能够实现30秒内小车行驶到规定点，并保持跷跷板平衡；在跷跷板一端配重可调整的情况下，小车也能自动找到平衡点并保持跷跷板平衡。-The single-chip design for the electric car P89V51RD2FN control of the core, the MSA-LD2.0 seesaw angle sensor real-time measurement of the tilt angle, the detection of black ST198 photoelectric sensor to monitor vehicle movement and guide lines.Photoelectric sensors and angle sensors in real-time measurement module to feed the signal to the microcontroller, using a dedicated sub-chip stepper motor driver TA8435H to PWM chopper-type stepper motor on the sub-stepping angle, control and regulation vehicle speed. The use of incremental PID control algorithm to ensure that the car can achieve balance with LCD RT128 × 64M time, angle and other parameters.After the test showed that: the performance car

LPC935单片机,带AD,DA的-LPC935 microcontroller, with AD, DA

two wire smbus using uC

MAGIC2103-ARM7开发板中的UART源程序代码-MAGIC2103-ARM7 development board of the UART source code