C8051F020单片机步进电机控制源程序

用C语言编写的对51单片机的非常准确的时钟程序可以显示年月日小时分钟秒-C language for 51 MCU very accurate clock procedures to date show hours minutes seconds

单片机开发，通过1302 18b20 1602液晶显示器，实现闹钟的功能-Single-chip development, through the 1302 18b20 1602 LCD, the realization of an alarm clock function

用 AT89C51、LED 数码管、按键、二极管等部分构成，能实现时钟日历的功能：能进行时、分的显示。也具有时钟，定时时间的设定，实现三路开关定时输出等功能。-With AT89C51, LED digital tubes, buttons, diodes and other components, to achieve clock calendar function: to carry out, the sub-display. Also has a clock, timer time setting, the realization of three-way开关定时output functions.

ATMEL的ATMEGA128驱动160×80液晶调试程序，包括串口收发数据，及报文处理-ATMEL the ATMEGA128 drive 160 80 LCD debugging procedures, including serial data transceiver, and the reported text processing, etc.

这是用asm编写的IOA口使用程序，是用16位的凌阳单片机汇编-This is asm2 prepared by the IOA I use the program is the use of Sunplus 16 MCU Series

先进PID控制及其MATLAB仿真(第二版)-Advanced PID Control and MATLAB Simulation (Second Edition)

利用FIFO数据结构,在8051单片机上实现全双工通讯,实现MODBUS通讯协议-Use of FIFO data structure, in 8051 to achieve full-duplex communications, realize MODBUS communication protocol

本程序是基于FM1702的射频卡读写器的单片机控制的C语言程序，所用单片机为AT89C52.-This procedure is based on the FM1702 RF card reader control of single-chip C-language program, using single-chip microcomputer for the AT89C52.

移动机器人摇杆手柄调速中(AD采集)，微控制器为MSP430，已成功调试用于机器人上！-Mobile Robot Control in the rocker lever (AD Acquisition), micro-controller for the MSP430, debugging has been successfully used on the robot!

P89CXX编程器控制CPU接收和控制程序-P89CXX programming control CPU to receive and control procedures