数字信号处理的程序集合之六，饱含数字信号处理的各种算法，是可以帮助学习信号处理的好东西...

matlab程序,可以很好的实现神经元网络需要的程序-matlab

ti DM6446 Workshop 编译DSP侧程序示例代码-ti DM6446 Workshop to compile sample code for DSP-side program

CCS下编写的EDMA数据传输程序，基于DM642芯片-CCS prepared with EDMA data transfer procedures, based on the DM642 chip

DM643开发板网络传输部分开发源代码，用于网络部分传输部分，是非常好的代码-DM643 development board network transmission as part of the development source code, in part for network transmission parts, is a very good code

TCPIP移植到DSP上的工程源码，包括与RTL8019以太网接口的程序。-TCPIP transplanted to DSP on the project source code, including those related to RTL8019 Ethernet interface procedures.

信息研讨会

使用器件TI DSP TMS320C5402，可在PC中直接使用播放器播放声音。-use devices TI TMS320C5402 DSP, PC can be used directly players to play a sound.

详细描述了C6455硬件接口配置工程，基于CCS3.3开发，工程实现功能将EMIF数据读出后写入ddr2，然后从串口中读取出来写入串口中。EMIF读写函数留有接口，串口读写也留有接口，工程亲测，在板卡上数据采集通路已经调试。

源程序是在VisualDSP环境下开发出来的，目标处理器是4片AD公司的TS1O1 DSP。IDE_FAT32用来在硬盘上创建FAT32文件系统；2）i2c_test编写IIC总线；3）codec_a_in_pal_cf_frame是加载到FLASH的程序，板子在脱离PC自动上电时会把PAL制的图像直接存到CF卡里，CF卡的文件系统是FAT16；4）codec_a_in_pal_buf_boottest是可加载的DSP图像直通程序；5）ADSP-TS101prog_driver是flash的驱动程序。-source of the VisualDSP environment developed, targeted four processor is the company"s AD TS1O1 DSP. IDE_FAT32 used in the drive to create FAT32 file system; 2) to prepare i2c_test IIC bus; 3) codec_a_in_pal_cf_frame FLASH is loading procedures, the board automatically from the PC on when power will be the PAL system images directly to CF card, the CF card is the FAT16 file system; 4) can be loaded codec_a_in_pal_buf_boottest DSP image through procedures; 5) ADSP-TS101prog_driver flash is the driver.

H.264 编解码程序，希望对各位有用，同时加强交流是才主要目标-H.264 codec procedures, in the hope that useful, at the same time to strengthen the exchange is only the main objectives of