tigersharc ts101 LINK口数据传输程序

基于matlab的DSP（数字信号处理）学习资料-Matlab based on the DSP (digital signal processing) study data

dm642下的saa7114解码芯片的驱动程序-dm642 the saa7114 decoder chip Driver

DSP/BIOS Driver Developer Kit 1.11 The DSP/BIOS Driver Developer Kit (DDK) provides a selection of pre-tested DSP/BIOS device drivers, and documentation on how to write a driver to the DSP/BIOS driver model, known as IOM. The DDK includes C source code for all drivers. The DDK 1.11 has been validated with CCS 3.1 and DSP/BIOS 5.20. -DSP/BIOS Driver Developer Kit 1.11 The DSP/BIOS Driver Developer Kit (DDK) provides a sel ection of pre-tested DSP/BIOS device drivers, and documentation on how to write a driver to the DSP/BIOS driver model, known as IOM. The DDK includes C source code for a ll drivers. The DDK 1.11 has been validated with CCS 3.1 and DSP/BIOS 5.20.

合众达开发板的基于dsp的串口通信（spi）源程序调试。-United Development Board of the dsp-based serial communication (spi) source code debugging.

基于TMS320C32的自适应滤波程序,已调试通过.可以和低通滤波做比较 观察其优点 开发环境-adaptive filtering procedures, has been through testing. Can low-pass filter and compared the observed advantages development environment

详细介绍了CCS开发环境，对进行DSP开发的用户很有帮助-Detailed information on CCS development environment for DSP development of the user helpful

利用dsPIC30f芯片控制三相交流感应电机驱动程序，SPWM信号生成，电机的启动和停止控制，对于驱动三相交流感应电机的研究入门人员有很大的帮助 。

F2812FLASH编程，嵌入到CCS2000中-F2812FLASH programming, embedded in CCS2000

源程序是在VisualDSP环境下开发出来的，目标处理器是4片AD公司的TS1O1 DSP。IDE_FAT32用来在硬盘上创建FAT32文件系统；2）i2c_test编写IIC总线；3）codec_a_in_pal_cf_frame是加载到FLASH的程序，板子在脱离PC自动上电时会把PAL制的图像直接存到CF卡里，CF卡的文件系统是FAT16；4）codec_a_in_pal_buf_boottest是可加载的DSP图像直通程序；5）ADSP-TS101prog_driver是flash的驱动程序。-source of the VisualDSP environment developed, targeted four processor is the company"s AD TS1O1 DSP. IDE_FAT32 used in the drive to create FAT32 file system; 2) to prepare i2c_test IIC bus; 3) codec_a_in_pal_cf_frame FLASH is loading procedures, the board automatically from the PC on when power will be the PAL system images directly to CF card, the CF card is the FAT16 file system; 4) can be loaded codec_a_in_pal_buf_boottest DSP image through procedures; 5) ADSP-TS101prog_driver flash is the driver.

基于DSP5416的FFT测试程序，ASM代码。-DSP5416 the FFT-based test procedure, ASM code.