Based on ST792012864lcd driver

机于s52的巡检系统的开发代码。从代码中可以看到整个系统的流程和上位机的通信协议的格式非常不错。-plane s52 of the Tour system development code. From the code, we can see the whole system and the flow of PC communications agreement very good format.

S-35390A是可以在超低消耗电流、宽工作电压范围内工作的2线CMOS实时时钟IC。工作电 压为1.3 ~ 5.5 V、可适用于从主电源电压到备用电池电压的宽幅电源电压。通过0.25 μA的计 时消耗电流和宽范围的计时电源电压，可大幅度地改善电池的持续时间。在使用备用电池工 作的系统中，内置的自由寄存器可作为用户备用存储器来使用。在主电源切断前存储在寄存 器中的信息，可在电压恢复后的任何时候读出。 本产品因为内置了时钟校正功能，所以可以在很宽的范围内校正因振荡电路的频率偏差所导 致的时钟数据的提前或滞后。通过此功能和温度传感器的结合，可根据温度变化来对时钟进 行校正，从而实现不受环境温度影响的高精度的计时功能-err

基于队列的Mega8 UART通信驱动程序 文件名:uart.c 编译：WinAVR-20070122 硬件：CA-M8X 时钟：外部4MHz-Queue-based communication Mega8 UART Driver file name: uart.c Compiler: WinAVR-20070122 HW: CA-M8X clock: external 4MHz

用单片机读写图像显示芯片SAA7114H的程序，并且可以接受红灯信号以及线圈信号的程序-literacy MCU Image Display Chip SAA7114H procedures, and the red light signal can accept and process signals in the coil

avr单片机矩阵键盘扫描程序。开发环境为iccavr。协助Proteus软件仿真。-Single-chip avr keyboard matrix scanner. Development environment for iccavr. To assist the Proteus software simulation.

P1.7～P1.0接发光二极管L8～L1，要求利用单片机内部定时器1，按方式1工作，每0.01秒T1溢出中断一次。要求编写程序模拟时序控制装置。开机第1秒钟L1、L3亮，第2秒钟L2、L4亮，第3秒钟L5、L7亮，第4秒钟L6、L8亮，第5秒钟L1、L3、L5、L7亮，第6秒钟L2、L4、L6、L8亮，第7秒钟8个发光二极管全亮，……一直循环下去。fosc=11.0592MHz-P1.7- P1.0 then LED L1 to L8, by using a timer internal microcontroller, a work by the way, every 0.01 seconds T1 interrupted an overflow. Simulation prepared timing control device. Boot 1 seconds L1, L3- liang, two seconds L2- L4, L5 three seconds, L7- liang, 4 seconds L6, L8-liang, 5 seconds L1, L2, L5, L7- liang, 6 seconds L2, L4, L6, L8- , 7 seconds 8-LED whole ... has been the cycle continues. 11.0592MHz fosc =

忙了很久,,终于找到在Keil 中加入汇编的方法-Busy for a long time, finally found in the Keil added to the compilation method

这是从网上找来的一个比较典型的PID处理程序，在使用单片机作为控制cpu时，请稍作简化。-It is found from the Internet a more typical PID treatment procedures, the use of single-chip microcomputer as the control cpu, please make some simplification.

功能完善的四层电梯程序。开门停8秒，上升或者下降一层用时5秒，有五秒倒计时数码管，楼层显示数码管，以及电梯内外楼层请求显示灯。-A well-functioning procedures for four-storey elevator. 8 seconds to open the door stopped, increased or decreased when a layer of 5 seconds, the 5 seconds countdown digital tube, digital tube display floor, as well as inside and outside the elevator floor indicator lights request.

非接触式无线巡更系统实现讲解，希望能给大家带来帮助-Non-contact wireless realize on Patrol System, I hope everyone can help