单片机编程的bcd码和hex码的互换，BCD2HEX 例子： c=BCD2HEX(0x255) //255 转成HEX为0xff c=HE...

66PP22A单片机dtmf解码程序,用于DTMF通讯 软解码方式-66PP22A SCM DTMF decoder procedures for communications DTMF decoder soft approach

我自己写的一个tcp/ip的代码，很短，用的是vc来做模拟调试的，具体的运行是要在mcs51单片机上的，只有一个端口。具体请大家看程序吧！-I wrote it myself a tcp/ip code, in a very short, it was vc do simulation testing, the specific operation is to mcs51 MCU, only one port. Please refer to specific procedures!

MSP430框架程序。适用于MSP430F449，其他型号需要适当改变。 不使用的中断函数保留或者删除都可以，但保留时应确保不要打开不需要的中断。 保留中断函数，编译器将会为BSL密码填充所有的字节。-MSP430 framework procedures. Applicable to MSP430F449, other models need to be properly changed. Do not use the interrupt function can be retained or deleted, but should be retained to ensure that do not open unwanted interruption. Retain the interrupt function, the compiler will fill all of the BSL-byte password.

pic 单片机红外接收分析仪的资料，PC软件部分，pdf文件格式，请参考使用-pic microcontroller infrared analyzer to receive the information, PC software, pdf format, please refer to the use of

一个实用的LED条型显示屏程序，采用PHLIPS P89C51RD2芯片，LED显示驱动板为1/16分扫。本程序已经成功应用于多种场合-A practical LED bar display procedures PHLIPS P89C51RD2 chip, LED display driver board for 1/16 sweep. This procedure has been successfully applied to many occasions

51单片机的多机串口互连 通信函数，提供缓冲区，通过P2口的输入决定从机号。在STC89C52，AT89S52上通过。-51 Single-chip interconnection of multi-machine serial communications function, providing a buffer, through the input port P2 from the machine its decision. In STC89C52, AT89S52 adopted.

12864LCD(带汉字库)显示遥控键值读取器 * * LCD型号：TS12864A-3（带汉字库）或兼容型号 控制器ST7920 * * MCU:AT89S52 ,晶体频率：11.0592MHz * * P0口为128*64LCD的数据 D0-D7 * * K17键按下，继电器吸合。K19键按下，继电器关闭 * * 显示程序在中断服务程序之中-12864LCD (with汉字库) shows the remote control key reader** LCD Model: TS12864A-3 (with汉字库) or compatible controller Model ST7920** MCU: AT89S52, crystal frequency: 11.0592MHz** P0 population is 128* 64LCD data D0-D7** K17 button pressed, the relay pull-in. K19 button pressed, the relay to close** display program in the interrupt service routine of

此程序为一排队机呼叫器,主要功能是：用键盘控制液晶显示实现485通讯,具体协议可参考《排队机通讯协议050609.doc》.编译环境为ICC-AVR6.3,采用了ATmega8芯片,晶振速率为6.0000Mhz-Queue for a beeper, the main function is : keyboard control LCD achieve 485 newsletters, reference specific agreement "Queue 050609.doc communication protocol." Build environment for the ICC-AVR6.3 using the ATmega8 chips, crystal rate of 6. 0000Mhz

单片机秒表课程设计-SCM stopwatch curriculum design

带遥控 带128*64LCD 带电子开关 -With remote control with 128* 64LCD with electronic switch