使用51单片机和usb ch375芯片，完成与pc之间的通讯

此程序为一排队机呼叫器,主要功能是：用键盘控制液晶显示实现485通讯,具体协议可参考《排队机通讯协议050609.doc》.编译环境为ICC-AVR6.3,采用了ATmega8芯片,晶振速率为6.0000Mhz-Queue for a beeper, the main function is : keyboard control LCD achieve 485 newsletters, reference specific agreement "Queue 050609.doc communication protocol." Build environment for the ICC-AVR6.3 using the ATmega8 chips, crystal rate of 6. 0000Mhz

根据公版自己做的usbasp板，添加了usbcdc。-According to the public version of their own to do usbasp board, added usbcdc.

51单片机C程序,学习单片机原理、硬件结构、扩展接口和编程语言。-51 Single-chip C procedures, learning Singlechip principle, the hardware structure, the expansion interface and programming languages.

这是介绍凌阳单片机基础的PPT教案！要是有学凌阳的可以好好看看它哦，个人感觉还不错！-This is the introduction Singlechip Sunplus based PPT lesson plans! If the school has Sunplus can look at it, oh well, personal feeling pretty good!

61505LCD的单片机驱动程序，此程序已在KEIL上调试成功-61505LCD microcontroller drivers, this procedure has been successful in KEIL debug

1总线通信协议应用实例-a bus communication protocol Application

实验采用七段码LED设计（数码管），显示直观；采用定时器中断，计时更准确；功能齐全，可随时启动、停止、清零，后者智能化程度更高。-Seven-Segment LED code using the experimental design (digital control), visual display using timer interrupt, a more accurate time functions, may at any time to start, stop, cleared, and the latter an even higher degree of intelligence.

利用Verilig编写CPLD读写EEPROM（74LC21）程序-Verilig prepared to use CPLD to read and write EEPROM (74LC21) procedures

12864的液晶屏驱动程序使用51单片机编写-12864

最新10位数字温度传感器AD7416驱动程序-latest digital temperature sensor AD7416 driver