臂uC/OS-

基于LPC2119的CAN驱动及例子 循环发送实例程序 简单的CAN中继器实例，用到验收过滤寄存器 CAN和RS232透明转发器 基于uCOSII的CAN和RS232透明转发器 等(based LPC2119 CAN drive and examples of this cycle of a simple example of CAN Repeater is cases, Register acceptance filter used CAN and RS232 transparent uCOSII transponders on the CAN and RS23 two transponders and other transparent)

综合实验源代码－捉小鸡-comprehensive experiment source code-catching chicken

uCOS在Cortex-M3芯片上的移植，使用IAR EWARM-uCOS in the Cortex-M3 chips transplantation, the use of IAR EWARM

基于STM32的示波器设计，使用UCOSII和GUI制作(STM32 based oscilloscope design, the use of UCOSII and GUI production )

这是关于UC/OS-II在ARM7上移植的源码，内容齐全，在网上被多次下载-This is on the UC/OS-II ARM7 transplant source, as complete, and the Internet being repeatedly downloaded

256个任务的uCOSII，包含十个.c文件和一个头文件-256 uCOSII tasks, including ten. C files and a header files

UCOSII UcosCore is a source pragram about UCOSII.-UCOSII UcosCore is a source pragram about U COSII.

ucgui在windows下的移植-ucgui windows in the transplant

1.板上的8 个按键分别分别代表数字1-8，按下一个按键将结果通过串口发送到PC机上显示； 2.使用两个定时器模块，分别定时为1ms 和100ms 产生中断，使用它们分别 产生1s的定时时间，将时间分别显示到数码管上； 3.外接PS/2小键盘，将按键的值通过串口显示到PC机上。(A panel of eight key representing the number 1-8 press a key the results sent through the serial port on a PC display (2) use two timer modules, respectively, of 1ms and 100ms timer generates an interrupt, use them, respectively, Produce the timing of the 1s, the time display to the digital control External PS/2 keyboard, the key value of displayed through the serial port to a PC.)

ucosII系统使用串口读取PLC控制器的信息；-read PLC data with uart on the ucosII system