rc500 c语言库函数，对RC500的开发提供了捷径

用51单片机模拟I2C，程序已调试可以使用-51 MCU simulation with I2C, procedures can be used to debug

这是关于Proteus仿真的源程序，用于ARM7的开发与实验-This is the source on the Proteus simulation for ARM7 Development and Experimental

该项目是用三态分时扫描法驱动法实行控制12×48个发光二极管的驱动，并实现串口通讯，内附原理图，程序，DATAsheet-The project is using three-state time-scanning method driven control of 12 × 48 LEDs of the drive, and the serial communications, containing schematics, procedures, DATAsheet

单片机开发-Single-chip development

用单片机设计电子音乐门铃，除了各个子程序外还包括音符节拍码数据表。 -Designed with single-chip electronic music doorbell, in addition to various routines, but also including key data sheet music beat.

实现了对红外遥控器的解码及响应，并能进行LCD显示。-Realize the infrared remote control decoder and response, and can carry out LCD display.

这是一个AD转换程序,可实现多路AD转换,其运行是基于凌阳的spc061A单片机-This is an AD converter, which enables multi-channel AD converter. its operation is based on SCM Sunplus the spc061A

c51单片机实验程序代码--流水灯、时钟、液晶驱动，串口异步通信、AD、DA、ROM 扩展、IO扩展等等，附原理图，对初学者很有帮助。-C51 single-chip experimental procedure code- water lights, clock, LCD driver, serial asynchronous communication, AD, DA, ROM expansion, IO expansion and so on, with schematic diagram, useful for beginners.

ps2键盘的命令集，编写键盘驱动时有用。EDH:置位/复位 LED 指示器。键盘右上角有三个 LED 指示器,分别反映 Caps、Num 和 Scroll 三个键的 锁定情况。参数字节如表 2 所列。 -ps2 keyboard command set, the preparation of useful keyboard-driven. EDH: Set/reset LED indicator. The upper right corner of the keyboard has three LED indicators, respectively, reflecting the Caps, Num and Scroll Lock keys in three cases. Parameter bytes as listed in Table 2.

单片机多机通信（从机程序）用LCD显示传输的数据0-Single-chip multi-machine communication (from the machine process) LCD display with data transmission 0- 99