at89c51ed2看门狗程序

51单片机的FIFO(先入先出)循环队列实现-51 SCM FIFO (first-in-first out) Revolving Queuing

U盘(实际是USB SD卡读卡器)的制作方案。 硬件构成：ATmega168+PDIUSBD12+SD 内附GCC源码和原理图。 开发环境是AvrStudio4.13 b528 + WinAVR200701-U disk (actually USB SD card reader) production program. Hardware: ATmega168+ PDIUSBD12+ SD containing GCC source code and schematics. Development environment is AvrStudio4.13 b528+ WinAVR200701

USB转串口程序，已经调试通过，调试环境为keilc.-USB to serial procedures, has been through the debugging, debugging environment keilc.

该项目是用三态分时扫描法驱动法实行控制12×48个发光二极管的驱动，并实现串口通讯，内附原理图，程序，DATAsheet-The project is using three-state time-scanning method driven control of 12 × 48 LEDs of the drive, and the serial communications, containing schematics, procedures, DATAsheet

很好的移动数字电视方案,LCD显示器显示图象.-A very good mobile digital TV solutions, LCD monitors display images.

运用凌阳单片机控制家庭电器（通过Internet网络）-use Sunplus SCM control household appliances (through the Internet)

C51很好的IO模拟串口程序，也称软件UART。只需用一个定时器，实现中断接收。程序编写得很规范，有很多个晶振频率和串口频率可选。是一个比较好的软件串口程序。-C51 a good simulation of serial IO program, also known as the software UART. Just use a timer to achieve interrupt reception. Programming very standardized, there are many a crystal oscillator frequency and the frequency of an optional serial port. Is a relatively good software serial programs.

通过单片机控制0832芯片实现数模转换 输出波形-0832 through the single-chip microcomputer to control the number of chip-to-analog converter output waveform

msp430F149 框架模块程序，很好用-framework msp430F149 module procedures, very good use

是一个利用单片机C语言生成各阶M序列的程序，还有发送程序-SCM is a C language generation of the M-series of procedures, there is this procedure