流水灯,用于熟悉了解单片机,初次上手的人用

单片机tcpip通讯-Single-chip communication tcpip

DOS 下的VGA 转 TV的芯片控制源代码,汇编编写.可直接使用-DOS VGA chip to control TV source code, compile prepared. Can be used directly

计时器检测要接计时器要用keil生成hex再用-Detection timer use the timer to take keil generate hex reuse

此C语言程序实现串行接口电压输出型D/A转换器MX532的控制。-This C language program serial interface voltage output type D/A converter MX532 control.

温度控制器V1.5 显示为三个共阳极LED 温度传感器用单总线DS18B20 CPU为2051，四个按键，分别为UP，DOWN，SET 温度调节上限为125度，下限为-55度 只能用于单只18B20-Temperature Controller V1.5 show for a total of three LED anode temperature sensor with single CPU for the bus DS18B20 2051, four keys, respectively UP, DOWN, SET temperature regulator ceiling of 125 degrees and lower limits of-55 degrees can only be used solely 18B20

液晶显示器以其微功耗、体积小、显示内容丰富、超薄轻巧的诸多优点，在袖珍式仪表和低功耗应用系统中得到越来越广泛的应用。 -LCD display with its micro-power consumption, small size, display rich content, ultra-thin lightweight many advantages, in the pocket instrumentation and low-power applications are more and more widely.

arm(44b0)端口初始化,在程序里面有较多的注释部分, 在具体情况下可用-arm (44b0) port initialization, the procedure has more notes inside part can be used in specific circumstances

此程序针对C8051F124，使用定时器3中断，用于点亮绿色小灯。-This program flashes the green LED used C8051F124 // using the interrupt handler for Timer3.

89C52单片机12M晶振下DS18B20温度传感器测量温度应用子程序源码-89C52 microcontroller 12M under DS18B20 crystal temperature sensor temperature measurement applications subroutine FOSS

这是一个波形选择菜单，通过开发板上的按键，选择波形，幅度，频率的等各参数，然后发送给下位机。让其产生需要的波形。-This is a waveform selection menu, through the development of on-board buttons, select the waveform, amplitude, frequency and other parameters, and then sent to the next bit plane. The need to generate the waveform.