单

LCD程序hmn 民间 搞活 才 各个-LCD HMN civil enliven the proceedings before a

我测试通过的液晶驱动汇编程序,适用于所有不带字库的液晶,如CA12864A-I tested the LCD driver compilation procedures, applicable to all non-character LCD, as CA12864A

用来显示LCM103的单片机程序。非常好的例子，里面有很好的编程习惯。-used to show the SCM process. Very good examples, they have a good programming practice.

该程序为t6963控制器的c语言驱动程序，内有proteus的模拟仿真图形，是单片机学习的好例程！-procedures for the t6963 Controller c language driver, proteus within the simulation, graphics, SCM is a good learning routines!

89c52 eprom 的子程序 可以参考一下 -89C52 eprom the subroutine can reference

基于16位单片机的符合osek标准的操作系统，在freescale的16位单片机上调试通过-Based on 16-bit MCU line with the OSEK operating system standard, in the Freescale 16-bit single-chip debugging through

电子屏字符显示器 电子设计， 解释清楚，一看即懂，简单明了 -E-Screen Character Display Electronic Design, explain clearly that one look to understand, simple to understand

DS1302，DS18B20，中断三个子函数，可直接调用。-DS1302, DS18B20, disruption of the three Functions can be called directly.

8253的初始化程序举例: 例1：选择2号计数器，工作在3方式，计数初值为533H（2个字节），采用二进制计数。其初始化程序段为 MOV DX，307H ；命令口 MOV AL，10110110B ；2号计数器的初始化命 令字 OUT DX，AL ；写入命令寄存器 MOV DX，306H ；2号计数器数据口 MOV AX，533H ；计数初值 OUT DX，AL ；选送低字节到2号计数器 MOV AL，AH ；取高字节送AL OUT DX，AL ；后送高字节到2号计数器 -8253 initialization procedures examples : Example 1 : Select counters on the 2nd, in three ways. Counting for the initial 533H (2 bytes), a binary counting. Initialization of its procedures for MOV DX, 307H; I ordered MOV AL, 10110110B; on the 2nd Counter initialize command word OUT DX, AL; write commands Register MOV DX, 306H; data on the 2nd Counter I MOV AX, 533H; Counting initial OUT DX, AL; low-byte sent to the 2nd Counter MOV AL, AH; With a high-byte send AL OUT DX, AL; evacuations high byte counter to the 2nd

这是一个智能小车的原理图，里面包括红外传感器的收发，液晶显示模块，方波产生模块，单片机控制模块等．-This is a smart diagram of the car, including infrared sensors inside the transceiver, LCD modules, square wave generated modules, SCM control module.