MSP430为MSP430串口GPS采用GPS接口程序…

ch375的USB驱动打印程序 很有用-ch375 printing process of the USB drive is useful

51单片机实现的温度测量、AD转换，温度传感器采用DS18B20，显示采用1602LCD屏，报警采用蜂鸣器。-。-51 MCU temperature measurement, police procedures, the use of temperature sensor DS18B20, showed that the use of 1602LCD screen, using buzzer alarm.

本人非常支持单片机设计DIY 在这里再次献出小弟的一点心意,下面是使用AT89S52驱动74HC4015,实现1选择8的数据通道切换器,可以在不8个通道出加上不同大小的电阻.可以用来单声道音量的大小控制. 下面作品图是小弟设计的廉价的 基于单片机的毕业设计 ,它还使用了无线接收发送模块,通过使用手上的遥控器能控制音量的大小,还加了一块HCF4052用于输入音道的选择,支持思路音频信号的输入,一路音频信号的输出: -I very much support the single-chip design DIY here again gave a little boy s mind is to use the following AT89S52 drive 74HC4015, to achieve a choice of 8 switches the data channel, you can not add the 8-channel resistance of different sizes. Can used to the size of mono volume control. The following work plan is designed小弟cheap graduation based on single-chip design, it uses the wireless receiver send module, through the use of the hands of the remote control can control the volume size, but also Add a piece of HCF4052 Road for the importation of sound choices, to support the idea of audio signal input, the output audio signal all the way:

8051两个单片机的通信，各自分别控制另一个单片机的跑马灯的左右跑动方向。keic工程文件-8051 2 MCU communication, each one separately control the left and right SCM ticker running direction. keic project file

利用单片机51加sl811芯片实现对u盘读写的控制，代码仅供大家参考，如有不对之处，敬请谅解-Sl811 increase the use of single-chip 51 chip on the u disk read and write control code for your reference, if doing so after updating

长沙理工自己的实验程序，从最基础的到高深一点的，都有。不过实验箱是我们学长自己设计的，其它的箱子要调试的话还需相应改动-Changsha Institute of Technology

TI Stellaris LM3S9B96 的 Datasheet，该 MCU 使用 ARM 公司 Cortex-M3 内核，为新的一代 MCU。-TI Stellaris LM3S9B96 the Datasheet, the MCU to use ARM" s Cortex-M3 core, as a new generation MCU.

串行接收、提取GPS报文信息，存于单片机内存单元。-this is resouse of gps reciever.

DS1302的驱动程序,C版的,测试过,好用-DS1302 driver, C version, tested, easy to use

数字频率合成器DDS9851的驱动程序实验-频 铣 DDS9851 实