建立 ARM Linux 交叉编译环境 一步一步讲解,很仔细的讲解了Linux 交叉编译环境的的建立, 一看就懂...

使用寄存器点亮led灯，是关于arm工程的，要与开发板结合使用，编程工具是keil5.

intel的PXA255芯片的中文资料，绝对详细的说明整块芯片的任何部件以及寄存器的设置和使用，是难得的资料，12M的文件足以看到它的份量了-The PXA255 chips intel Chinese data, the absolute detail of the entire chip, as well as any components register to set up and use, the information is a rare, 12M documents sufficient to see it the weight of the

PHILIPS ARM7内核系统芯片的亮LED灯小程序-PHILIPS ARM7 core chip system-small LED lights procedures

网上找来的 STM32F103的简易串口驱动(查询方式) -Online found the STM32F103 simple serial driver (inquiry method)

AT9261在ADS下面的8个代码，一般网站只提供3个代码！-AT9261 in ADS the following 8 code, the general site code only 3!

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

MSP430F149键盘输入程序，利用msp430f149单片机的p1端口输入-MSP430F149 keyboard input program, the use of the port input msp430f149 SCM p1

samsung s3c4510的booterload源代码，对s3c4510的开发者有帮助-S3C4519 Bootloader source code, it s helpful for developer!

sniffer_queued — — — — 基于 stm32This 是一个改进的嗅探器。不同于基本的 sniffer_ascii 和 sniffer_binary 项目，该项目进一步添加帧队列应用程序 （由受体组件提供） 中。此队列可以大大降低帧丢在嗅探器 node.attention 的概率： 如果嗅探器正忙着在输出前一帧通过缓慢的 UART 与计算机，在此期间的连续的帧可能会丢失。

ARM平台上的RS485通信,接受发送都使用中断方式-ARM platform on the RS485 communications, has accepted the use of this interrupt