GSerial under DOS is a serial communication program, program structure better, c...

8583芯片编程应用写入器件地址写8574端口，写入器件地址读8574端口。-8583 Application Programming chip device addresses written into the 8574 port, write device address read 8,574 ports.

该程序实现了串口之间的相互通信，是异步串口通信，串口编成程序-Implementation of the procedures between the serial communications, serial communication is asynchronous, the classic experimental procedures for computer networks

华邦单片机W77E58的中文芯片资料,给广大英语薄弱的程序开发和爱好者跟好地掌握W77E58使用带来了方便.-Winbond Singlechip W77E58 Chinese chip information to the general procedure for the development of English is weak and enthusiasts with a good grasp W77E58 brings convenience to use.

这个文件夹里共3个部分，分别是串口编程与ODBC技术结合，用API函数控制串口和用MSComm控件控制串口。-This folder in a total of three parts, which are serial programming and ODBC technology, using API functions to control serial port and serial port control by MSComm control.

电机驱动监控系统，已经通过现场运行验证，绝对能用。-motor drive control system, has been verified through field operation, absolutely can be used.

一个好用的经过FPGA验证的i2c_slave verilog代码。-After a useful FPGA proven i2c_slave verilog code.

串口通信该有的都有了,而且样子也不错.大家看后多给意见咯,对了如果有更好的创已请于我联系-the serial communication have some, but looks good. We see multiple views to argue for the better if the founding has been requested to contact me

使用说明： 系统要求：WIN9X/ME/NT/2000 VC++6.0 且安装了VC ACTIVEX控件（在VC6安装时选上） 免费 简介：在VC++6.0中用MSComm控件编程，可以实现串口接收数据和发送数据，数据分别显示在接收框和发送框中。-Usage: System Requirements: WIN9X/ME/NT/2000 VC++ 6.0 and installed VC ACTIVEX controls (in VC6 installation selected) Free Introduction: In VC++ 6.0 using MSComm control programming can be achieved Serial receive data and send data, data were displayed on the receiver box and sent box.

自己写得串口多线程控制程序，里面的超时设置和书上说得不是很一样，大家参考吧-their written control procedures for multi-threaded, overtime set up inside the book and put it is not very like, we make reference to it

wavecom短信猫使用源代码及相关AT指令-Wavecom message cat use the source code and related AT commands