利用５１单片机做的一个电子时钟，用１６０２显示，已经实现．...

单片机51环境下的字库代码122*32点阵的液晶显示-under the font code 122* 32 dot-matrix LCD

本系统参照片上系统的设计架构、采用FPGA与SPCE061A相结合的方法，以SPCE061A单片机为进程控制和任务调度核心；FPGA做为外围扩展，内部自建系统总线，地址译码采用全译码方式。FPGA内部建有DDS控制器，单片机通过系统总线向规定的存储单元中送入正弦表；然后DDS控制器以设定的频率，自动循环扫描，生成高精度，高稳定的5Hz基准测量信号。-The system with reference to the design of system-on-chip architecture, used a combination of FPGA and SPCE061A approach to SPCE061A Singlechip for process control and scheduling core mission FPGA for external expansion, internal self-system bus, address decoding using the entire translated code approach. DDS has built internal FPGA controller, microcontroller through the system bus to the provisions of the storage unit into the sine table DDS controller and then to set the frequency, automatic cycle of scanning, to generate high precision and high stability of the baseline measurement 5Hz signal.

Elan EM78P458 AD转换。

使用C51单片机进行二进制转换源码的算法介绍-The use of C51 single-chip source binary conversion algorithm introduced

51上的RTOS，该RTOS为非占先式多任务操作系统，如果用户任务的最长执行时间小于 系统节拍时间，则本MiniRTOS要优于占先式TOS。因为本MiniRTOS占用资源小，RAM不超过20字节，程序空间只占为600多字节。-51 on the RTOS, the RTOS non-preemptive multitasking operating system, if the user of the longest task execution times smaller than system beats time, it is superior to the MiniRTOS Preemptive 200040. Because of the small resources MiniRTOS occupation, RAM no more than 20 bytes, procedures only for the space of more than 600 bytes.

由于arm板的键盘扫描程序，c语言编写。-As the arm board keyboard scanner, c language.

在proteus可以实现国际象棋功能！！ ！1-Proteus can be achieved in the chess features! ! ! 1

Keil C51编写的Aduc812的完整代码，适合学习使用Aduc812单片机进行AD_da处理 -Keil C51 prepared by the Precise code of integrity, Precise suitable for learning to use the MCU for handling AD_da

基于AT89S52的万年历C51程序 开发平台：Keil uVision2 日历芯片：DS1302-AT89S52 of C51-based development platform calendar: Keil uVision2 chip Calendar: DS1302

STM32的工程模板,基于IAR5.40的ST固件库V3.1.0,提供GPIO实例-STM32 project template, the ST-based IAR5.40 firmware library V3.1.0, providing GPIO instance