project template using very convenient locations download application beginners

自己写的温度显示程序，在开发板上可以验证成功 -Write their own temperature display program in the development of on-board can verify the success of

用L298作为驱动器，控制两相混合式步进电机。 按键从上至下分别为减速，加速，正转，反转，停止。 具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。 转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

能够将语音先进行录制，然后在回放，适合应用在一些需要语音播报功能的设备上-Able to carry out a voice recording, playback and then, suitable for broadcast in a number of the needs of voice-enabled devices on the

飞利浦RC522芯片源代码。该芯片主要针对三表市场和手持设备，支持I2C/SPI/UART接口。 先发布基于普通51单片机的驱动源代码，采用串口接口，无需中断。只要接一个串口，后续会发布基于飞利浦LPC9401的读写源代码！LPC9401也是基于51核，只需连接SPI接口！有公司拿这个源代码卖钱哟-Philips RC522 chip source. The chip targeted at three tables and handheld devices market, support I2C/SPI/UART interface. Based on the first general release 51 MCU-driven source code, using serial interface, without interruption. As long as a serial port access, the follow-up will be issued based on the Philips LPC9401 write source code! LPC9401 is based on the 51 nuclear, only connecting SPI interface! A company with the source code acquisition yo! !

I2c的通信协议 主控端。 没有写从端。不好意思-I2c Zhukongduan the communication protocol. No written from the end. Sorry.

用AVR单片机实现对时钟芯片DS1302的spi驱动，来读取和写入时间-AVR Microcontroller with the right of the spi clock chip DS1302 drive to read and write times

斜度计的MSP430程序，挺好的程序，大家-Gradient of MSP430 procedures, very good procedures for U.S.

ds1302,我自己做成功了,可以下载就直接用!-ds1302, to do my own successful, can be downloaded directly using!

用89S51做的红外编码解码程序。载波用555做-89S51 do with the infrared codec procedures. Carrier to do with 555

液晶模块12864中文次料-LCD module times expected 12,864 Chinese