使用NI M系列采集卡产品的DIO数字通道模拟I2C时序，读写EEPROM LABVIEW实例（原创），采用LABVIEW8.5编程。...

单片机与嵌入式系统教材简介.pdf-microcontroller and embedded systems briefing materials. Pdf

掉电保护数据 数码管数据显示不变 按复位键也没用 掉电 上电数据从停止的地方开始数-yesbushi wobuhuia

ADC0809是广泛使用的模／数转换器，在可不采用外部总线结构的单片机系统中(如 由AT89C51组成的系统)。ASC0809的数据线直接与单片结构的I／0 口相连，并由单片机的I／O 口直接对ADC0809进行控制。-ADC0809 is widely used in analog/digital converters, in not using the external bus architecture in the single-chip microcomputer system (such as the composition of the system by the AT89C51). ASC0809 data lines directly with the monolithic structure of I/0 I connected the MCU I/O port directly to control the ADC0809.

ds1820的源码驱动-The source driver ds1820

伺服马达控制的C51程序。 文件： sifu*.c sifu*.Uv2 sifu*.hex 等相关文件。-Servo motor control of the C51 program. File: sifu*. csifu*. Uv2sifu*. hex and other relevant documents.

红外资料，详细的介绍了一些红外的资料，内容比较详细-Infrared data, a detailed introduction a number of infrared data, content in more detail

模拟串口实现代码, Baud: 9600Bps , Format: 1,8,1,无校验位, MCU:M88 , CRYSTAL:3.6864M , ICC AVR6.31A , 占用定时器T0(工作在查询方式) ,在项目中使用,收发一切正常.-Simulation of serial code, Baud: 9600Bps, Format: 1,8,1, no parity bit, MCU: M88, CRYSTAL: 3.6864M, ICC AVR6.31A, occupation timer T0 (in query mode), in the project use, send and receive all normal.

这是一个数码管的程序，运行于iar的环境下，适用于msp430的单片机-This is a digital control procedures, running on iar circumstances, apply to MSP430 microcontroller

7281键盘显示程序，经过验证，可以直接使用-Keyboard display program 7281, after verification, can be directly used

Keil工程建立及设置-Keil establishment and the provision of engineering