用中断实现的一个四*四的键盘程序。在Keil C下开发的。程序通过。...

基于msp430的液晶显示模块LCM141-MSP430-based liquid crystal display module LCM141

时钟芯片PCF8563的51单片机程序 时钟不超过12MHZ，本程序已在51上试过，可以用-PCF8563 clock chip clock of 51 single-chip program does not exceed 12MHZ, this procedure has been tried in the 51

根据公版自己做的usbasp板，添加了usbcdc。-According to the public version of their own to do usbasp board, added usbcdc.

共搜集了13个有关51单片机的一些基本程序，代码有汇编写成，内容包括计数器、温度检测等等。-collected a total of 13 of the 51 SCM some of the basic procedures, a compilation of code written, including counter, temperature measurement, and so on.

一个红外接收的程序，对红外遥控的设计具有一定的参考价值-An infrared receiver of the procedures, the design of infrared remote control has a certain reference value for

针对小容量单片机的任务调度，不必使用操作系统，做小项目很合适-For small capacity single-chip task scheduling, do not have to use operating system, is very suitable to do small projects

用89S52进行DS1820温度读取程序-89S52 used for DS1820 temperature reader

电力变电站RTU监控软件（80C196NT单片机） 遥控，遥信，遥调，遥测，谐波分析等，FFT算法等,LCD显示-electricity substation monitoring software (80C196NT SCM) remote control, remote, distance transfer, telemetry, harmonic analysis, the FFT algorithm, LCD Display

由SPCE061A控制的74hc595的驱动程序,一般用于串转并-by SPCE061A 74hc595 control of the driver, generally for serial switch and

主要用到了PID算法控制温度,显示采用动态扫描.输出可调节占空比的脉冲控制加热器-mainly used to control the temperature PID algorithm, shows that using dynamic scanning. Output adjustable pulse duty cycle control of the heater