红外 verilog 旋风 3

说明：  基于labVIEW，控制电机等工作实例，程序基本完整(Based on labVIEW, control motor and other working cases, the program is basically complete)

design and implementation of a format conversion system on the Altera NIOS board(QUARTUS) which reads an analogue input, converts it into digital data, and then does the reverse conversion back into analogue format. This will be done by taking an analogue an analogue input using SPI MCP3202 12-Bit A/D converter to generate the digital data stream and then the digital data will be used to generate an analogue output using Analog Devices 8-bit SPI AD7303 D/A converter.

STM32F107几种功能demo：串口，定时器，外部中断，systick，看门狗等实例

基于压缩感知的ISAR方位向成像以及与FFT成像对比(CS-based ISAR imaging and RD imaging)

basys3的数字钟，可以显示00.00-59.59(Digital clock of basys3,It can display 00.00-59.59)

ds1302时钟驱动程序，已在quartus上验证可以是直接使用(DS1302 clock driver, which has been verified on quartus, can be used directly)

这是一个完整的工作模块编码在 verilog 检测的旋转车轮的旋转速度。它也给旋转的方向。这可以在 fpga 板直接实施，此模块内还有一个特别的小模块，以生成测试信号的面积。所以你不需要连接一个车轮与旋转编码器来测试 speedo 米。这就是独一无二的关于此模块 ！！！cheerz!! 享受

说明：  spartan6学习资料，官方资料，用户手册，包括5个主要文件(Spartan 6 Learning Materials, Official Materials)

XILINX 时序约束使用指南笔记 ——时序约束介绍 时序约束方法 时序约束原则等(XILINX time series constraints use guide notes -- time series constraints introducing time series constraint principles, etc.)

The AGC is a smart programmable gain amplifier (PGA). The amplifier gain is adjusted based upon the input signal level so that the output is at a specified Target Gain. The AGC can be configured to be either a mono or stereo input / output component. For illustration purposes, the following discussion will highlight the stereo configuration.