使用C语言编写单片机液晶显示程序，此程序是对于AT89S52单片机的程序源码。只需通过编译来生成HEX文件...

利用单片制作信号发生器，该源码是针对51+DAC0832，所产生的一系列波形，有正弦波、方波，并把相应的波形打印到lcd上显示-Making use of single-chip signal generator, the source for 51+ DAC0832, a series of waves generated, there are sine wave, square wave, and the waveform corresponding to the lcd display print

CH375 主机文件系统接口(支持FAT12/FAT16) MCS-51单片机C语言的U盘文件读写示例程序-CH375 host file system interface (support FAT12/FAT16) MCS-51 single-chip U of C language sample programs to read and write disk files

ADC0809做的数字电压表，0-5V，4个LED直接接单片机做显示，动态扫描写的驱动-ADC0809 do the figures in Table 0-6 voltage- 5V, 4 LED SCM done directly, dynamic scan was driven

采用PDIUSBD12开发的USB总线与429总线数据转换的单片机固件程序-used PDIUSBD12 development of the USB bus with 429 data conversion MCU firmware

传感器接口说明:从左到右依次为通道1,地,通道2 功能:在数码管上显示传感器接口通道2输入的电压 小数部分为7位,整数部分1位-Sensor Interface Description: from left to right channel 1, and channel 2 functions: to show possession in the digital sensor interface channel 2 voltage input for the fractional part of 7, an integral part of

代码为单片机与液晶模块的接口电路程序以及显示程序，适用于用单片机实现液晶模块显示的初学者-Code for the microcontroller and LCD module interface circuit procedures and display program for display LCD module with MCU for beginners

LPC单片机I2C编程-LPC SCM I2C programming

空孩子3310的程序，给需要的朋友－－－－－pcf8848-3310 children

用ADuC8xx单片机实现AD转换、DA转换、片内flashdata的操作、定时器、计数器和I2C通信的源码-with ADuC8xx MCU AD converter, DA conversion, Chip flashdata operation, timer, counter and I2C communications FOSS

电动车里程表,安装在自行车上,能显示当前速度,显示总里程数,可以用来做别的,抛砖引玉-Electric vehicle odometer, installed on the bike, can display the current speed, showing the total mileage that can be used to do anything else, start