PIC4455 ADC source for PICC18 compiler, PIC16 series does not apply

51-320240液晶操作程序-51-320240 LCD operations

AVR单片机 用的是ICC开发环境 DS18B20温度采集,LCD1602B显示 MCU : Atmeag16-AVR Singlechip ICC using a development environment DS18B20 collecting temperature, LCD1602B show MCU: Atmeag16

keyboard TI TMPS430单片机使用例子，希望对象我一样的初学者有帮助-keyboard use TI TMPS430 SCM example, I hope that the same object is to help beginners

温度控制识别 温度控制识别 -fjdkjafkljdljalfld

单片机与温度传感器的应用ds18b20，很多错的。请大家踊跃下载啊。-SCM and temperature sensor application ds18b20, many wrong. Please download ah enthusiastically.

这是一个基于 8051 的图形化GUI栈，好好用 占用资源很少-This is a 8051-based graphical GUI stack, good with small footprint

Mifare1 S50 IC卡密钥替换工具，用作卡初始化-Mifare1 S50 IC card key replacement tools, used for card initialization

一个实用的LED条型显示屏程序，采用PHLIPS P89C51RD2芯片，LED显示驱动板为1/16分扫。本程序已经成功应用于多种场合-A practical LED bar display procedures PHLIPS P89C51RD2 chip, LED display driver board for 1/16 sweep. This procedure has been successfully applied to many occasions

本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求，其工作原理是：先将真空管关闭，启动电机，用低真空气流将塑料树脂粒子送入真空管，电机停转，再将粒子排入料斗，如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in accordance with the requirements of its working principle is: first vacuum tube to close, start motor, using low vacuum plastic resin particles will flow into the vacuum tube, the electrical switch to stop, and then particles into the hopper, and so the cycle.

用C51实现的拼音输入法,这是改写的网友 embuffalo、独步上载在www.21ic.com自由发布区的由张凯原作的51上的拼音输入法程序。 原作使用了一个二维数组用以查表，我认为这样比较的浪费空间，而且每个字表的索引地址要手工输入，效率不高。所以我用结构体将其改写了一下。就是大家现在看到的这个。 因为代码比较的大，共有6,000多汉字，这样就得要12,000 byte来存放GB内码，所以也是没办法的 :-( 编译结果约为3000h,因为大部分是索引表，代码优化几乎无效。 在Keil C里仿真芯片选用的是华邦的W77E58，它有32k ROM, 256B on-chip RAM, 1K on-chip SRAM (用DPTR1指针寻址,相当于有1K的片上xdata)。条件有限，没有上片试验，仿真而已。 打算将其移植到AVR上，但CodeAVRC与IAR EC++在结构体、指针的定义使用上似乎与C51不太一样，现在还未搞定。还希望在这方面有经验的网友能给予指导。-C51 with the Pinyin input method, which is rewritten netizens embuffalo. Unrivaled www.21ic.com available in the free publication of the original work by Kai-51 on the Pinyin input method procedures . Appreciate the use of a two-dimensional array for the look-up table, I think this is a waste of space. Each of the characters but the index table to manually input address, efficiency is not high. I use the structure to rewrite a bit. We see now is this. Because the code comparison, a total of 6, more than 000 Chinese characters, this must