IIC_slave硬件的代码，已经经过FPGA验证

获取当前机器的COM口的数量，包括usb转换的串口-access to the current machinery of the number of COM ports, including USB Serial Conversion

串口通信控制器的Delphi例子-Serial Communication Controller Delphi examples

8155扩展程序，可以进新键盘和数码显示的扩展，是一个不错的源代码-8155 expansion procedures, can enter the new keyboard and the expansion of the digital display, is a good source

USART的驱动程序，在C++编译环境下，进攻学习参考-USART the driver, in the C compiler environment, learning offensive reference

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

FPGA中实现rs232串口通信程序，上位机和FPGA互发数据-FPGA to achieve rs232 serial communication procedures, each host computer and FPGA-fat data

6017FM在山景音响初始化程序，效果很好！-6017FM in Mountain View, audio initialization procedure, good results!

一本介绍串口通信不错的书-introduced a serial communication good book

delphi1 的串口通讯控件，经过改进的-delphi1 serial communication control, improved

短信控件版本4.0应用于短信二次开发。接口程序-SMS Control Version 4.0 applies to SMS redevelopment. Interface