带遥控的液晶显示程序，液晶是1602，遥控器是普通的电视机遥控器...

系统can地址为550,用于can系统测试,应用T0定时器每隔1s向can总线发送一组数据:数据长度为8个字节, 首字节为05H,第二个字节为累加变量,每秒钟数值增加1,-system can address 550 for the test system can, Application T0 1s to every timer can send a bus of data : data length of 8 bytes the first byte of 05H, the second byte of cumulative variable, an increase in value per second.

freescale mc9S08DZ60 IRQ C语言外部中断程序-IRQ

数控直流稳压电源，单片机实现直流数控稳压电源,可调电压为0-12伏,步进为0.1伏

基于AD89S52的控制AD7705的液晶显示源程序。-Control of AD7705 based on AD89S52 source of the liquid crystal display.

用vc++实现的双踪示波器程序源码 用vc++实现的双踪示波器程序源码. 用vc++实现的双踪示波器程序源码-With vc++ Realize the dual-trace oscilloscope program source with vc++ Realize the dual-trace oscilloscope program source code. Using vc++ Realize the dual-trace oscilloscope program source

基于MCS―51系列单片机的按键程序，包括扫键，按键算法等一系例思想和代码。-Based on MCS-51 series single-chip key procedures, including the sweep key, key algorithm, such as Example 1 Department of ideas and code.

利用５１单片机做的一个电子时钟，用１６０２显示，已经实现．-51 Singlechip done using an electronic clock, with 1602 show that has been achieved.

三相步进电机的三相六拍工作方式，正转的绕组通电顺序：A、AB、B、BC、C、CA、A，反转的通电顺序：A、AC、C、CB、B、BA、B、A。 由于步进电机转子有一定的惯性以及所带负载的惯性，故步进电机的工作过程中不能及时的启动和停止，在启动时应慢慢的加速到预定速度，在停止前应逐渐减速到停止，否则，将产生失步现象。 步进电机的控制问题可总结为两点： 1、产生工作方式需要的时序脉冲； 2、控制步进电机的速度，使它始终遵循加速、匀速、减速的规律工作。 -Three-phase three-phase stepper motor six shot work, is to order the winding power: A, AB, B, BC, C, CA, A, reverse the order of power: A, AC, C, CB, B, BA, B, A. As the stepper motor rotor has a certain degree of inertia, as well as brought about by the inertia load, the stepper motor during the course of work should not start and stop time, start to be slowly accelerated to a predetermined speed, the stop should be to slow down gradually to the stop, otherwise, will result in out-of-step phenomenon. Stepper motor control problems can be summarized in two points: one, resulting in the need to work the timing pulse 2, control the speed of stepper motor, so that it always followed acceleration, velocity, deceleration of the law of the work.

实现交通灯功能的汇编程序.-achieve functional traffic lights compilation process.

《单片机原理与实用技术》第1章-"SCM principles and practical technology," Chapter 1