单片机控制带中文字库12864液晶屏，程序中包括显示汉字，显示图片等功能。...

零耗时低频宽脉冲软PWM信号控制Keil C51演示程序，转摘！-zero time-consuming low-bandwidth pulses Soft PWM control signal Keil C51 demo program, journals!

C8051F040/// /////多消息can接收程序-C8051F040//////// more information can receive procedures

我老师为上课开发的单片机测试源程序，怎么可能“文件已存在”？-my teacher for the class of MCU development test program, how likely "file already exists?"

有电路图和程序,都是正确的.如果有问题可以到我的博客 去留言,大家相互学习-A circuit diagram and procedures are correct. If the problem can go to my blog to the message, we learn from each other

单片机发生的讲解，不懂得可以看看!-the SCM talks, do not know how to look at!

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

触摸屏测试实验,AVR控制,使用ICC语言-Touch-screen testing laboratories, AVR control, the use of ICC language

使用PWM6输出PWM信号，通过滤波电路实现DAC转换。-The use of the output PWM signal PWM6 through the filter circuit DAC conversion implementation.

sja1000两点通信实验，从程序即可看出硬件连接-SJA1000 two communications experiment, the procedure can be seen from the hardware connection

采用CYGNAL F015单片机，用于一个电池老化试验柜（即循环充放电）的实用程序，实现了SMBUS总线通信协议。-used CYGNAL macroeconomic microcontroller, for a battery aging test counters (that is, charge-discharge cycle), the practical procedures to achieve the SMBUS bus communication protocols.