LCD1602在KEIL下调试的DLL。

C51的跑马灯程序-C51 5,250 procedures

C Flash Drivers for the AT89C51RD2_ED2_ID2 for Keil Compiler rev 1

这是从51上移植过来T6963的源码和Proteus。用CodeVisionAVR编写的。-This is a transplant from a 51 on the T6963 and the source Proteus. Prepared with CodeVisionAVR.

用AVR编写的24小时时钟程序，还望采纳-AVR prepared with a 24-hour clock procedures, but also look to adopt

利用DS18B20采集温度，显示温度到lcd上-DS18B20 collected using temperature, shows that the temperature on the lcd

i2c通讯C程序源代码,经测试合格,可以放心使用,请注意时钟周期-i2c communication C program source code, have been tested and qualified, you can rest assured that the use of, please note that clock cycle

用单片机读写图像显示芯片SAA7114H的程序，并且可以接受红灯信号以及线圈信号的程序-literacy MCU Image Display Chip SAA7114H procedures, and the red light signal can accept and process signals in the coil

CC1110无线收发TDMA的源程序。使用的开发环境是IAR7.2H-TDMA wireless transceiver CC1110 source. The use of development environment are IAR7.2H

用于C51上的modbus协议，经测试可运行，但还不完善-C51 for the Modbus protocol, the tests will be run, but still not perfect

用于步进电机的驱动.可以通过输出信号来控制步进电机的转速和角度控制.-For stepper motor driver. Can output signals to control the stepper motor speed and angle control.