PID处理C源程序

C8051F040 UART0模式1全双工通信 uart0模式1主机程序-C8051F040 UART0 a full-duplex mode of communication uart0 a mainframe model procedures

这是应用在Philips的D12上的源代码。很有用的哦。-These source code applies in D12 of Philips,it s very valuable.

本程序已经调试通过，使用I2C来从外部时钟芯片中读取并写入时间。文档包含i2c的驱动程序、时钟芯片的读与写、以及使用定时器中断产生脉冲来模拟gps对时。-This procedure has been debugging through the use of I2C chip from the external clock time to read and write. Document contains the i2c driver, the clock read and write chip, and the use of the timer interrupt to simulate the pulse generated when the gps on.

avr单片机atmega8,ad转换测试程序，本程序为试例程序，适用于初学者-avr SCM atmega8, ad conversion, testing procedures, the procedures for test cases procedures applicable to beginners

模拟遥控器编码，可是模拟三个按键的编码，用c语言编写。-Simulation of the remote control code, but simulate the three keys encoding, using c language.

基于凌阳GPCE061板，由C和汇编嵌套组成的MXIC串行flash驱动程序。-Based on Sunplus GPCE061 board, from C and assembler comprising nested MXIC serial flash driver.

51单片机开发的8道门出入记录控制板，具有RTC时钟功能，同时具有声光抱紧，能实时的记录被监控门的打开时间。本案例只有8路，但可以方便的扩展至32路。-51 MCU development of 8 door access control panel recorded with RTC clock function, both sound and light to hold fast, can be monitored real-time record of the time the door opened. This case is only 8-way, but can be easily extended to 32.

超声测距c语言程序 利用定时器产生40khz站空比50 的方波 通过检测收到超声波的时间来测距-Ultrasonic Ranging c language program generated using the timer 40khz space station more than 50 of the square wave by detecting the time to receive the ultrasonic ranging

YEKA手机数据线驱动pl-2303hx drv-clubs mobile data line drive pl-2303hx Drv

个人做的基于AVR单片机的一个简易数字钟，用C语言写的，希望各位多多指教。-Individual to do a simple microcontroller-based AVR digital clock, using C language to write, and hope that the exhibitions.