ATmaga128 串口通信程序 （可实现收发数据和字符串）

在单片机上实现电子书功能，带proteus仿真 -In the realization of electronic functions on single chip with proteus simulation

有急于51单片机IIC的操作讲解，和at24c02的一些基本资料，和IIC读写基本操作！-51 Single-chip IIC eager to have the operation on, and AT24C02 some basic information, and IIC to read and write basic operation!

路设计大全》中国铁道出版社 随书光盘 [AltiumDesigner.rar] - 这个电子教程介绍了AltiumDesigner软件的使用方法 [USB2.0-CY7C68013-128S.rar] - USB2.0开发板完整电路图,protel99se格式... -Road Design Encyclopedia

通过对红外线工作原理的了解，进行红外线的C语言编程-SDFSFSFS

AVR单片机开发EEPROM读写实验源程序-AVR single-chip EEPROM read and write to develop the experimental source

介绍了一种基于MCS251 系列单片机的温度测控电路。可对外界温度进行测 量、误差修正、判定传感器故障与高温报警, 并具有键盘控制和警情通讯显示功能。-VERY GOOD

三相步进电机的三相六拍工作方式，正转的绕组通电顺序：A、AB、B、BC、C、CA、A，反转的通电顺序：A、AC、C、CB、B、BA、B、A。 由于步进电机转子有一定的惯性以及所带负载的惯性，故步进电机的工作过程中不能及时的启动和停止，在启动时应慢慢的加速到预定速度，在停止前应逐渐减速到停止，否则，将产生失步现象。 步进电机的控制问题可总结为两点： 1、产生工作方式需要的时序脉冲； 2、控制步进电机的速度，使它始终遵循加速、匀速、减速的规律工作。 -Three-phase three-phase stepper motor six shot work, is to order the winding power: A, AB, B, BC, C, CA, A, reverse the order of power: A, AC, C, CB, B, BA, B, A. As the stepper motor rotor has a certain degree of inertia, as well as brought about by the inertia load, the stepper motor during the course of work should not start and stop time, start to be slowly accelerated to a predetermined speed, the stop should be to slow down gradually to the stop, otherwise, will result in out-of-step phenomenon. Stepper motor control problems can be summarized in two points: one, resulting in the need to work the timing pulse 2, control the speed of stepper motor, so that it always followed acceleration, velocity, deceleration of the law of the work.

ADI公司，型号为ADuC814的单片机的I2C总线通讯程序源码，含MASTER和SLAVE两种方式-ADI, model for the SCM ADuC814 I2C bus communication program source code, including the MASTER and SLAVE two ways

C51七种实用子程序集3-C51 seven practical subroutine Set 3

用汇编语言写的风扇转速测试程序,用于转速测试,传感器用KEYENCE-using assembly language to write fan speed test procedure for testing speed, the sensor used KEYENCE