C2000 Bootloader大规模生产中的应用

x25045的读写源程序，可以读x5045和写x5045，软件模拟spi总线协议。-x25045 source reader, can read and write x5045 x5045, software simulation of 20 bus protocol.

VC++ 编写开发的VMR视频采集与显示程序源代码，采用directshow 和vmr7 控制视频采集卡，采集并显示视频 ，VC6.0下调试通过。测试时需要安装好测试所需的摄像头、采集卡等硬件设备。本源码主要是想让学习一下VC++的视频采集技术。

基于ARM7的44B0开发板的DMA测试程序，C语言编写，可以在ADS1.2上运行-ARM7-based development board 44B0 of DMA test procedure, C language, you can run ADS1.2

Dragonball相机驱动-Dragonball camera drive

MP3系统中USB接口设计，自己去看吧，我就不多介绍了，反正有用--USB port design in MP3 system.

arm9 强大功能boot,对于arm9 的开发支持非常之好，调试，引导，擦写，上传，等很方便-arm9 power boot, for the development of arm9 very good support, debugging, and guide, write, upload, and very convenient

实现HY29V160FLASH的操作源代码，采用汇编和C的混合编程，相信对大家很有帮助-HY29V160FLASH achieve operational source code, compilation and use of the hybrid C programming, we believe that the right helpful

ucLinux is a very good embeded sytem. Most of company use this as their development OS.-ucLinux is a very good embeded sytem. Most o f company use this as their OS development.

每次开机都将次数加1 并存储到EEPROM。这样就能直观的看到机器的使用次数。用P1口 LED做为显示，次数大于256是将溢出，按复位模拟开机 或者直接通过开关开机。-Each boot will add a number of times and stored in EEPROM. This will be able to see the intuitive usage of the machine. As with the P1 port LED display, frequency is greater than 256 is the overflow, according to reset the boot, or directly through the analog switch boot.

LCD显示源程序，基于6963控制器-LCD display source, based on the 6963 controller