MSP430 routine, from the EW430 select tools, is a simple procedure

模型参考自适应程序。用于无速度传感器，做矢量控制-matlab

基于DS18B20温度传感器的设计程序 要求为：第一，由DS18B20获得外部温度信息然后通过数码管显示，显示值为三位，两位整数，一位小数。第二，判断温度是否大于 50℃，若温度在50℃以上，显示红色发光二极管发光；若温度在50℃以下，显示绿色发光二极管发光。-DS18B20 temperature sensor based on the design of procedural requirements: first, by DS18B20 access to external temperature information through a digital display, showing a value of 3, two integer, a decimal. Second, to determine whether the temperature is greater than 50 ℃, if the temperature at 50 ℃, which indicates that the red light-emitting light-emitting diodes if the temperature below 50 ℃, showing a green light-emitting diode LED.

PT2253+SC6122+PT2258+PT

DSK5416的mcbsp应用.本人调试过,保证正确-Application of the McBSP DSK5416. I have been debugging to ensure that the correct

可以存储最多50个电话信息，包括序号，姓名，地址，电话。具有查找，浏览，修改，添加，删除，查看上一个，下一个记录等功能。注释详细，在masm615下汇编运行。-Can store up to 50 telephone information, including the serial number, name, address, telephone number. Have to find, browse, modify, add, delete, view, on one, the next record function. Note detailed compilation of the masm615 to run under.

8*8 LED 点阵屏幕显示全屏下滚2次及上滚2次,从左到右,从右到左各收缩1次.从中间扩展到四角,从四角收缩到中心,然后再显示:"祖国您好 合肥市 邦森公司 国庆" 作为LED点阵练习,简单易懂.-8* 8 LED dot-matrix display full-screen under the roll-on roll 2 times and 2 times, from left to right, from right to left each contraction 1. From the middle extended to the four corners, from the contraction to the center square, and then displays: " Fatherland Hello, Hefei, Bunsen" s National Day" as a LED dot matrix exercise, easy to understand.

汇编小程序 多种方法解冒泡法排序 以masm 5.0以上版本编译运行 -small compilation method for a variety of procedures Bubble Act to masm ranking above version 5.0 compiler operation

Sinusoidal Control of PMSM Motors with dsPIC30F DSC

This a sample of OUT instruction. It writes values to virtual I/O port that controls the stepper-motor. Try using datCCW, datCW_FS or datCCW_FS instead of datCW to get different behavior of the motor. -This is a sample of OUT instruction. It writes values to virtual I/O port that controls the stepper-motor. Try using datCCW, datCW_FS or datCCW_FS instead of datCW to get different behavior of the motor.

显示彩色矩形块等汇编-color display, such as the compilation of rectangular block