CC1100射频电路的线路板和已经调通的源码

Proteus做的仿周立功ARM开发板，欢迎大家学习-Proteus weeks to do the imitation Ligong ARM development board, welcome everyone to learn

tcpip的一些源码,希望对大家能够有用,使用与嵌入式开发-tcpip some source code, in the hope that everyone can be useful, use and Embedded Development

单片机控制减速电机，红外循迹，壁障，运水，08年黑龙江电子大赛题目-Single-chip motor deceleration control, infrared tracking, barrier, transport, water, Heilongjiang in 2008 e-Competition Title

步进电机加减速运行程序 步进电机启动时，转速由慢到快逐步加速 步进电机匀速运行 步进电机由快到慢逐步减速到停止-Stepper motor stepper motor deceleration run the program starts, the speed gradually from slow to fast speed stepper motor stepper motor run by a uniform approaching slowly and gradually slow down to stop

单片机汇编语言编写的IC卡读写程序--IC card read/write program for SCM. It is written in assembly language.

单片机系统上电后，P0 口和 P1 口都被清 0。然后，你规定一个由 6 个数字构成的序列（每个数字从 0～F 中选取），比如 E、8、9、0、7、F。然后每次当单片机检测到外部中断 0发起中断时间时，读取 P0 口和 P1 口上的状态值，当连续 6 次外部中断事件的对应的数字序列构成你所设定的序列后（举例来说，如果 P0.0 是 1，P0 和 P1 的其他管脚是 0，那么我们称为检测到一次数字 0），从串口打印输出一幅类似下图的 16×16 的ASCII码的圣诞树图片。-Single-chip microcomputer system after power, P0 and P1 mouth I have been ching 0. Then you set a six figure constituted by the sequence (each number from 0 ~ F in selected), for example, E, 8,9,0,7, F. And then each time a single-chip detects external interrupt 0 initiated interruption time, I read the P0 and P1 mouth on the state value, when a row 6 times the corresponding external interrupt events constitute digital sequence set your sequence (for example example, if P0.0 is 1, P0 and P1 of the other pin is 0, then we called a number of detected 0), a printout from the serial port under similar 16 × 16 map of the ASCII code of the Christmas tree图片.

AT24C64程序-AT24C64 procedures

本程序实具有低功耗性能的16位单片机msp430实现AD转换功能-This procedure has a low-power performance is the 16-bit single-chip MSP430 realize AD conversion

采用C51编写的基于C8051F020单片机的电机测速使用程序。-using C51 prepared by the C8051F020 Motor gun procedures.

采用51系列单片机硬件电路对TEA5767收音模块控制源码-51 Series single-chip hardware circuit of TEA5767 radio module control source