单片机控制减速电机，红外循迹，壁障，运水，08年黑龙江电子大赛题目...

F_Dtecter 单片机频率计 精确度1％以上 -Singlechip F_Dtecter Cymometer more than 1 accuracy

模拟高频头的 驱动程序（搜台、换台等功能）-Simulation of high-frequency driver first (found Taiwan, for Taiwan, and other functions)

单片机(51,AVR,MAP430,PIC)的模拟软件的源码-SCM (51, AVR, MAP430 PIC), the simulation software source code

由8051组成的单片机系统通常情况下，P0口分时复用作为地址、数据总线，P2口提供A15-A8即高8位地址，P3口用作第二功能，只有P1口通常用作I/0口。P1口是8位准双向口，它的每一位都可独立地定义为输入或输出，因此既可作为8位的并行I/O口，也可作为8位的输入输出端。当工作在输入方式时，对应位的锁存器必须先置1,才能正确地读到引脚上的信号,否则,执行读引脚指令时,若对应位的锁存器的值为0，读的结果永远为0。-By 8051, composed of single-chip microcomputer system under normal circumstances, P0 timeshare I reuse as address, data bus, P2 I provide A15-A8 high eight address, P3 mouth for the second function, I usually only P1 for I/0 I. P1 I was eight quasi-two-way port, it can be independent of each and every defined as input or output, it can be used as 8-bit parallel I/O port, can also be used as 8-bit input and output side. When the work in the input, the corresponding bit latch must first buy one in order to correctly read the signal pin, or pin the implementation of reading instruction, if the corresponding bit latch the value of 0, Reading the results of Forever to 0.

SMC162S实现时钟，可以计时，即实现数字时钟-Realize SMC162S clock, can be a time, that is, digital clock

在Iccavr软件平台上，提供一个具有通用性的 mega Bootloader，不同型号的AVR单片机只需要修改一下几个简单的配置参数就可以直接使用了，不需要再修改主程序。-In Iccavr software platform to provide a universal mega Bootloader, different models of AVR Singlechip you only need to modify a few simple configuration parameters can be used directly, no need to modify the main program.

tlc5615的驱动程序。程序也用过，比较好， 非常高兴能和大家分享。-tlc5615 drivers. Procedures used were relatively good, and very pleased to share with you all.

ConnectOne 工业级wifi模块的相关文档，串口通信．可以和单片机相接，及我在ＰＣ机端能过串口测试时的指令（带注释）-Industrial ConnectOne class documentation wifi module, serial communications. Single-chip can be connected, and at my PC over the serial terminal to test the command (with Notes)

SD2000时钟芯片读写程序-SD2000 clock chip to read and write procedures

X5043读写程序，非常少见的可以直接调用的源代码，对你非常有帮助-X5043 to read and write procedures, very rare direct call to the source code, and for your very helpful