7279的C代码.可在KEIL的环境任意移植.

单片机外部中断 串口中断 定时中断 单片机外部中断 串口中断 定时中断 -micro conctol micro conctol micro conctol micro conctol

PS2接口协议，PS2与单片机的接口,用单片机的同志有服气了-PS2 interface protocol, PS2 and microcontroller interface, the MCU is convinced the comrades

32位arm9微处理器S3C2410的rtc实时时钟测试源代码

此子程序将进行AD转换和AD处理，处理后的12位AD值中低八位存放在 adc_buffer_low中，高四位存放在adc_buffer_hi寄存器的低四位-This subroutine will convert to AD and AD treatment, treated in the low 12-bit AD value stored in the adc_buffer_low eight, the high four storage registers in the low 4 adc_buffer_hi

本设计采用凌阳16 位单片机SPCE061A对步00进电机进行控制，通过IO口输出的具有时序的方波作为步进电机的控制信号，信号经过芯片L298N驱动步进电机；-This design uses 16-bit single-chip Sunplus SPCE061A to step into the motor control 00, through the IO port with the output timing of the square wave as a stepper motor control signal, the signal after the chip stepper motor driver L298N

CC2420初始化程序，使用CC2420快速入门源码-CC2420 initialization procedures, the use of CC2420 QuickStart source

一些LCD库 分享给大家了 哈哈~-LCD library share some of the U.S. ha ha ~

自己编写的一个单片机控制红外发送与接收的红外发射源程序,同时自己也做了一个板实验,是成功的哦-I have written a single chip to send and receive infrared control of the infrared emission source and at the same time also made a plate experiment was a success, oh

一个用单片机控制饲服电机的程序，采用ＯＭＲＯＮ光纤感应器实现的剪纸机，已通过调试-By feeding a single-chip microcomputer to control the electrical service procedures, the use of fiber-optic sensor OMRON realize the paper-cutting machines, has passed through debugging

为LCD12232F写得驱动程序，主控核为凌阳SPCE061A，连接方式请根据程序中的注释连接，工程可下载直接使用。-LCD12232F written for the driver to master the nuclear Sunplus SPCE061A, connections in accordance with the procedures of the Notes connection, works can be downloaded directly used.