怪胎，液晶显示模块

用WAVE6000开发环境写的电子钟程序-WAVE6000 development environment used to write procedures for electronic bell

24c64子程序，主程序直接调用就可以使用

一个很有用的单片机实例,你在此例中会学会很多单片机系统的操作-Singlechip a useful example in this case you will learn a lot of single-chip microcomputer system operation

本代码实现了两块无线收发模块prt8000（核心芯片nrf905）的通信功能-This code has two wireless transceiver module prt8000 (core chip nrf905) of the communication function

16*16点阵源C程序，keil开发,可以显示32个字,从左到右滚动显示。-16*16

移动硬盘固件程序，拿很多MONEY买的，这个也非常好哟！-Mobile hard disk firmware, get bought a lot of MONEY, this is also very good yo!

用５１芯片控制CF卡的技术文章，对广大５１开发者具有参考价值-control CF card chip technology articles, the majority of 51 developers have reference value

单片机的键盘矩阵程序，用c语言编写的。绝对的正确，经过机子调试过的。-SCM procedures keyboard matrix, with c language. Absolutely correct, after testing machine before.

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

c8051f020 的扩展8255驱动数码管显示 同样是keilc啊-C8051F020-driven expansion of 8255 is a digital tube display the same keilc ah