A clock program which is suitable for any LCD display! Developer can use it with...

c51下的一个键盘程序，用循环轮训法检测是否有键按下。-c51 keyboard under a procedure used in rotation cycle of detection whether key press.

无线遥控主机程序，对应的与无线遥控副机程序配合使用。-wireless remote mainframe procedures, corresponding with wireless remote control deputy with the use of aircraft procedures.

modem 原程序。用于无线模块的开发应用GPRS应用--Modem source code. It could be used in developing wireless module.

8051单片机的5x7点阵显示代码。这将显示连续滚动的字符串。 ；

详细的嵌入式bootloader解释，很有用-Embedded bootloader detailed explanation, very useful

efax.pdf

用uCLinux开发嵌入式网关-with uCLinux embedded gateway

&纵观历史，我们发现

zigbee 2430 演示 就是个演示程序么 说这么多干嘛 晕-zigbee 2430 demo is a demo so much for doing what halo

总的来说，在uClinux上的开发和标准Linux还是很类似的。通常可以按照下面的步骤去设计和调试： 建立基于以太网的开发环境； 如果所设计的程序和硬件的关联不大，那么一定要在标准Linux上先编译和调试通过。灵活地使用gcc和gdb将大大节省时间； 将x86上的GCC编译好的应用程序用交叉编译工具来编译；如果编译时发现错误，那么很可能存在以下问题： 交叉编译器或库文件的路径不正确；最彻底的解决办法是重新装一次编译器； 遇到库不支持的函数；此时需要自己把函数的实现做成另外一个库供应用程序使用。如果是uClinux本身不支持的调用，那么就需要改写代码了。-Overall, the uClinux on the development and standard Linux is still very similar. Usually can use the following steps to design and debug : Ethernet-based development environment; If the design of the procedure and not linked to the hardware, then it must be the first standard Linux compiler and debugging through. Flexibility in the use of gdb and gcc will greatly save time; X86 will be on the GCC-compiled application with cross-compiler tool to compile; If you compile time error is found, it was very likely that the following issues : cross-compilers or libraries are not the correct path; The most radical solution is a re-installed time compiler; encountered does not support functions; At this time the need to