用LPC2106做的ARM开发板

MSP430F149键盘输入程序，利用msp430f149单片机的p1端口输入-MSP430F149 keyboard input program, the use of the port input msp430f149 SCM p1

这是一套关于ARM开发的培训教程的PPT文档.-This is a set of ARM development of training curricula of the PPT document.

2440开发板的硬件接口使用手册，好东东呢-2440 development board hardware interface user manual does a good Dongdong

一些ARM入门的原代码， 和大家分享下。-Introduction to some of the original ARM code, and under the U.S. share.

ms51 控制sl811读写u盘的源程序 及 原理图 可仿真试一下 -ms51 control u disk read and write sl811 source and schematic simulation to try

AVR mage8单片机的bootload程序、完整版本、本人做项目一下在用、此程序为8m晶振版本、非常好用-MCU AVR mage8 Bootload procedures, full version, I do projects like the use of this procedure for 8m crystal version, very easy to use

使用MC9S12DP256写的CAN转串口程序。-use MC9S12DP256 CAN write to the serial procedures.

ARM培训教材PPT：包括ARM架构、ARM调试方案、ARM开发技术、指令集介绍、典型开发方案等，初学者可以参考一下。-ARM training materials PPT include : ARM architecture, ARM debugging programs, the development of ARM technology, instruction set, the typical development program, and beginners can take a look.

在ＡＲＭ２４１０支持汇编指令集，可在Ｓ３Ｃ２４１０上运行．-ARM2410 support in the compilation instructions, the S3C2410 running.

嵌入式输入法码表源码,支持二级汉字字库(6535)-Embedded source code table input method to support the two Chinese characters (6535)