在keil上移植uc/osII的例子

这是针对凌阳SPCE061A芯片的一个uCOS系统的移植包，里面成功开了三个任务，在61板上稳定运行,是我做毕设时移的一个包,开发工具是凌阳的IDE，-this is a UCOS code that can run in the SPCE061A ,inclue 3 task , pass the test on a develop bord!

small c for z80 从PART1到4-small c for Z80 to four from PART1

stm32SD读卡器和模拟U盘源代码，实现了USB接PC后的2个盘符的源代码(This is a SD reader and Nand disk from USB to PC,All of source code)

我 Porting 的 uC/OS-II V2.84 (目前Micrium)最新版之 Keil C51 工程,专供给 8051 上做任务调度,我已将 Code Size 改小至 4000 Byte,对于 X-Ram 的用量也仅 160 Byte(于 Keil C51 V8.08a 下编译后).我在 Main.c 内创建了两个任务调度的 LED 闪烁程序,方便了解任务是如何被创建的,同时我也在 Keil C51 的 Project 内设好了 Simulator 模式及 Port 1 窗视可即时的观测这两个任务调度情况.-I Porting the uC/OS-II V2.84 (currently Micrium) the latest version of the Keil C51 works exclusively on the supply of 8051 to do mission scheduling, I have Code Size改小to 4000 Byte, the usage of X-Ram is only 160 Byte (in Keil C51 V8.08a compiled). I main.c create two task scheduling of the LED flashing procedures to facilitate the understanding of how the mission was founded at the same time I Keil C51 is also equipped with the Project Good the Simulator Mode and Port 1 window, as can be observed real-time task scheduling of these two cases.

ARM的bootloader程序的bin文件-ARM

MC68hc908JL16的UCOSII代码-MC68hc908JL16 the UCOSII code

压缩包内是ucos在ARM上的移植的一套比较完整的代码-compressed within the ARM OUT is the transplantation of a more comprehensive code

一个全面的UCOSII开发软件包，包含源代码，相关的说明文档及使用文档。-UCOSII the development of a comprehensive package, including source code, related documentation and use of documents.

ucosII系统使用串口读取PLC控制器的信息；-read PLC data with uart on the ucosII system

想深入的学习UCOS2实时OS就应该读他的原码，-Would like to UCOS2-depth study of real-time OS on him should read the original code,