ucOS下AD实验程序,可以任意更改AD寄存器的地址

μC/GUI 是一种用于嵌入式应用的图形支持软件。它被设计用于为任何使用一个图形LCD 的应用提供一个有效的不依赖于处理器和LCD 控制器的图形用户接口 指针实现(μC/GUI is a graphical support software for embedded applications. It is designed for any application using a graphical LCD to provide a valid pointer to the graphical user interface does not depend on the processor and LCD controller)

移植在鱼板上运行的ucos-transplant operation in the fish board ucos

UCOS-II FOR STM32F103XX 1 本程序是我自己移植，只使用KEIL进行过软仿真，测试没有发现问题。支持从任何一个中断服务程序里释放信号量。 2 此代码作为参考和学习使用，如果在使用过程中造成损失，本人不负任何责任。 3 此代码作为参考和学习使用，因为里边有UCOS-II，如果要作为商业使用请给UCOS付费。-UCOS-II FOR STM32F103XX 1 This procedure is my own transplant, carried out using only soft KEIL simulation, testing did not find the problem. Support from any one of interrupt service routine release semaphore. 2 of this code as a reference and learning to use, if in the use of the process of loss, I no responsibility. 3 of this code as a reference and learning to use, because inside has UCOS-II, if we as a commercial use, please pay uCOS.

此代码是我精心调试而成，内有NOKIA3310驱动，无刷电机驱动，还有UCOS嵌入式操作系统，在电路板上调试成功-This code is from my well-debug, which have NOKIA3310 driver, brushless motor drive, there are uCOS embedded operating system, the success of the circuit board debugging

介绍了ucos在ARM上移植过程与注电事项-Describes the ucos the ARM note on the migration process and electrical items

UCOS的源码，它的硬件基础是80186，只要你的电脑只要是INTEL的CPU，就可以在你的电脑上面正常运行，你也可以把它移植到你的MCU，所以这个源码是研究UCOS的最佳选择。-UCOS the source, and its hardware is based on 80,186, as long as your computer as long as it is INTEL" s CPU, on your computer in the normal operation of the above, you can transfer it to your MCU, so the source is to examine the UCOS the best choice.

UCOS II源码 内含SOURCE 解压后使用 -UCOS II intron SOURCE source unpacked use

C/OS-II 命令熟记 C/OS-II 命令熟记 C/OS-II 命令熟记(C/OS-II command memorize C/OS-II command memorize C/OS-II command memorize)

本例程基于正点原子迷你stm32开发板，跑ucos-iii驱动DHT11(the program is run to stm32, it`s for ucos driver dht11 module, display temp&humi)

uC/OS-II是一个简洁、易用的基于优先级的嵌入式抢占式多任务实时内核。上述代码为uC/OS-II在X86的安装程序-uC/OS-II is a concise, easy-to-use priority-based preemptive multi-tasking embedded real-time kernel. The above code for uC/OS-II in the X86 installation process