USB编程器原理手臂

波形发生器isotransferloader-waveform generator isotransferloader

Usb2.0原码及其详细资料,包含USB2.0详细资料及调试助手代码。-USB2.0 original code and its detailed information, including detailed information on USB2.0 and debug the code assistant.

使用USB与8051通讯，包括源代码。

FT245BM USB FIFO芯片文档。芯片使用时的很全的文档-Document FT245BM USB FIFO chip. Chips use very-wide document

USBFX2LK WDM drive for OSR s USB FX2 Learning Kit

一个用vb开发的源代码-vb development with a source code

用CY7C630芯片做USB转串口的汇编原程序,里面有编译生成的hex文件.写入芯片就可使用.最高波特率为24-do with CY7C630 chip USB to Serial compilation of the original procedure, which has compiled documents generated hex. The chips can be used. The highest baud rate for 24

USB 飞力浦固件开发源码:基本业务处理功能，完整开发文档，已编译通过-the USB source of Philips: the base function ,all empolder source code,can compile OK.

USB设备端固件程序,枚举部分是全部程序的基础和重心,只有主机对设备枚举成功后,主机才能和设备进行正常的通信 USB的枚举过程分为4个状态. 1.接入态 v主机检测到USB设备插上,击活端口,并发送复位命令(保持10ms) 2.默认态 v主机使用默认地址读取设备描述符 (GET_DESCRIPTOR) v主机分配给设备一个总在线的唯一地址 (SET_ADDRESS) 3.地址态 v主机从新的地址获取设备描述符(GET_DESCRIPTOR) v主机获取所有设备的配置描述符(GET_DESCRIPTOR) 4.配置态 v主机设置描述符(设备,配置) (SET_CONFIGURATION) v主机读取配置状态(可选) (GET_CONFIGURATION) v主机读取接口状态(可选) (GET_INTERFACE) -USB device-side firmware, enumerate all part of the foundation and focus of the procedure, only the host of equipment after the successful enumeration, the host and equipment in order to engage in normal communication USB enumeration process is divided into four status. 1. Access state v host detected USB devices plug in, hit live ports, and send the reset command (to maintain 10ms) 2. default state v Use the default address of the host to read device descriptor (GET_DESCRIPTOR) v host assigned to the equipment of a total online only Address (SET_ADDRESS) 3. A

usb 的开发文档，非常有参考价值 详细讲述了CY7C68013的开发过程-usb development documents, a very valuable reference for a detailed account of the development process CY7C68013