a PWM duty cycle output procedures EM78P458 applications through debugging

89s51单片机控制的键盘和led系统，键盘送数led从低到高位的显示-89s51 MCU control of the keyboard and led system, the keyboard to send a few led from low to high Show

LT_1B msp430开发板例子程序－TA_10

红外遥控接收 ORG 0000H LJMP START 转入主程序 ORG 0010H START: MAIN: JNB P2.2,IR LJMP MAIN 以下为进入P3.2脚外部中断子程序，也就是解码程序 IR: MOV R6,#9 SB: ACALL DELAY882 调用882微秒延时子程序 JB P2.2,EXIT 延时882微秒后判断P3.2脚是否出现高电平如果有就退出解码程序 DJNZ R6, SB 重复10次，目的是检测在8820微秒内如果出现高电-infrared remote control receiver ORG 0000H LJMP START into main program ORG 0010H START : MAIN : JNB P2.2, IR LJMP MAIN below to enter P3.2 foot external interrupt subroutine, which is decoding procedures IR : MOV R6, SB# 9 : Calling ACALL DELAY882 882 microsecond delay subroutine JB P2.2, EXIT 882 microsecond delay after the judgment whether there P3.2 feet to I quit if decoding procedures DJNZ R6, SB repeated 10 times, the purpose is to test if within 8,820 microsecond high

此资料包含非接触式射频IC卡原理图源程序说明资料.-RF IC CARD information

MSP430F14x的范例程序，包括串口通讯、并口通讯-MSP430F14x examples of procedures, including serial communications, parallel communications, etc.

此程序为本人在公司开发的继电器功能测试仪，用KEIL C编写。可以测试线圈电阻，接触电阻，吸合释放电压，时间等参数。采用WINBONG W77E58 单片机。-This procedure I developed Relay Functional Tester, using KEIL C preparation. To test the coil resistance, contact resistance, pull-release voltage and time parameters. Singlechip WINBONG W77E58 used.

很好的AT89C51的中文说明书 费了很大劲才找到的-AT89C51 good Chinese manual costs a lot劲才found

51+sl811读写U盘的源程序＋原理图。想用51完成U盘读写的网友可参考参考。-51 sl811 reader of the source disk U+ diagram. With 51 to complete U-reader may refer to the website reference.

I2C总线协议及其软件的实现，非常使用！！！！单片机用的-I2C bus protocol and software to achieve the very use! ! ! ! The MCU

数字频率合成器DDS9851控制系统的单片机源代码，键盘输入频率，液晶显示，并实时输出所需频率，该系统可选择输出方波和正弦波。-Digital Frequency Synthesizer Singlechip DDS9851 control system source code, keyboard input frequency, liquid crystal display, and real-time output frequency required, the system can choose the output square wave and sine wave.