CDMAgonglvkongzhideMATLABfangzhen

支持向量机,可以在MATLAB环境下运行.(Support Vector Machines can be run under MATLAB environment.)

This code is about migration of seismic data.

采用matlab/simulink，简单通用电池模型及其参数测量(Using matlab/simulink, a simple generic model and its parameters measured battery)

direct neural controller

This program generates a color signal as the input signal and a desired signal of the idetification plant

This simulation demonstrates the starting of a DC motor with automatic starter (5 hp 240V 1200 rpm) rated torque Tr = 30 N.m The starter is simulated by a speed-dependent effective armature resistance using a look-up table

在系统辨识中，关键的是系统建模这里提出了多种方法(In system identification, system modeling is the key to a variety of methods presented here)

应用四步相移法实现包裹相位的解缠，另有解缠结果(Application of four step phase shifting method to achieve the wrapped phase unwrapping, otherwise the unwrapping results)

跳频（占空比为0.1）4fsk的部分频带干扰误码率计算，这个程序是基于matlab的，自己编的，呵呵(Frequency Hopping (duty cycle 0.1) 4fsk the partial band interference bit error rate, this procedure is based on matlab, and their series, Oh)

这是我用matlab亲自编写的结构光光条提取，并且有自己的改进策略，里面还有我对结构光条提取的详尽的分析(This is my personally written article structure light extraction with matlab)