电子锁源码

uclinux讲座之（二）.rar-Basis (2). Rar

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

S3C2410A对SST39VF160 NOR FLASH编程-S3C2410A for SST39VF160 NOR FLASH Programming

基于arm7板的录音程序，在三星的板子上测试通过-Based on the ARM7 board recording procedures, the Samsung

Atmel Uart C51程序（从方式）-Uart (from the way)

这是S3C44B0的BIOS或BOOT LOADER 程序中详细介绍了启动代码和FLASH 的读写 这很容易移植到其它ARM芯片-S3C44B0 This the BIOS or BOOT LOADER detailed procedures for the boot code reader and FLASH This can be easily ported to other ARM chips

通过PC并口模拟I2C信号，编写sharp stV0288 芯片驱动，在VC++环境下编译通过。-PC parallel port through I2C signal simulation, prepared sharp stV0288 chip-driven, the VC environment compile.

s3c2440开发板的pcb元件库，Altium Designer 6.6 格式-S3C2440 development board

uCOS移植范例,开发人员或嵌入式爱好者可以借鉴。-uCOS transplantation example, developers or embedded lovers can learn from.

at91rm9200的用户手册,内含windows下超级终端和linux下minicom的配置应用-AT91RM9200 user manual contains HyperTerminal under windows and under linux the configuration of the application of MINICOM