在C51上显示四个数码管程序，简单易懂，试用过

8051单片机上4*4矩阵键盘的扫描方式5-none

该文件是关于使用AT892051产生pwm控制的电动机的资料。-The document was produced on the use of AT892051 pwm motor control information.

基于凌阳61和pwm电机实现的智能车总程序，包含所有程序。-Sunplus based pwm motor 61 and realize the overall process of intelligent vehicles, including all the procedures.

基于飞利浦 lpc2104 arm7 微处理器的部分程序-Microprocessor-based Philips lpc2104 arm7 Part of the procedure

包含了msp430单片机上的ADC、定时器A、定时器B、基础时钟、看门狗的初始化及中断程序。基本示例程序-Msp430 on a single chip that contains the ADC, timer A, Timer B, basic clock, watchdog and interrupt the initialization process.

这是基于89C51单片机的实用热水器监视器源程序，程序由汇编语言编写-This is based on the 89C51 of usable water heater monitors source, procedures prepared by the assembly language

USB(即Universal Serial Bus)是一种通用串行总线。随着技术水平的提高，计算机的广泛应用，人们对串行通信提出了更高的要求。开发一种兼容低速和高速的技术，从而为广大用户提供一种可共享的。可扩容的。使用方便的串行总线成为众多厂商的共同目标。为了实现整个计算机系统中总线的一致性，USB已发布了一种成为通用计算机串行技术规范，简称为USB。-USB (or Universal Serial Bus) is a Universal Serial Bus. With the skill levels improve, the wider use of computers, serial communication of a higher demand. The development of a compatible low-speed and high-speed technology, so as to provide a vast number of users can be shared. May be the expansion. Easy-to-use Serial Bus has become the common goal of many manufacturers. In order to realize the entire computer system bus consistency, USB has released a general-purpose computer serial become technical specifications, referred to as USB.

本程序为简单的12232F型LCD液晶显示及键盘功能程序 K1键为进入调整，进入后显示四个0，再次按下为退出调整，初始状态 为首行显示河北工程大学 K2键为进入调整后加一 K3键为进入调整后减一 K4键为光标右移 -This procedure is simple 12232F-LCD liquid crystal display and keyboard function keys for entry into the program K1 adjust, enter the show after four 0, once again press for the withdrawal adjust, line shows the initial state, headed by Hebei University of Engineering K2 adjust keys for entry into the after One key for entry into the K3 adjusted by one for the cursor keys K4 shifted to right

51单片机写的液晶显示程序（1602），调通的，供初学者参考-51 Single-chip LCD written procedures (1602), tune

pic单片机定时器和计数器的初始化程序，定时器0定时100ms，计数器T1计数外部脉冲个数，查寻方式-Single-chip timers and counters pic initialization procedure, Timer 0 Timing 100ms, external pulse counter counts the number of T1, search methods