MCS

用ansi c 实现针对时钟芯片HT1380的驱动程序，以及实现电子时钟的源码-with ansi c achieve against the clock chip HT1380 driver, and the realization of the electronic clock source

DS1302的读写，基于MS430F149的读写，简单-DS1302 reading and writing, based on reading and writing MS430F149, simple

pc key control code you can use it

状态1：正常时，8个LED发光二极管（彩灯）循环点亮。 • 状态2：有报警时，蜂鸣器发出报警声（用P3.3接一个按键，模拟产生报警信号。当开关合上，发生报警；当开关断开，报警停止。用P3.7输出音频信号驱动扬声器，作为报警信号），同时8个LED发光二极管（彩灯）闪烁。 P3.2接一个按键，用于消除报警-Status 1: normal, eight LED light-emitting diodes (lantern) light cycle.

系统can地址为550,用于can系统测试,应用T0定时器每隔1s向can总线发送一组数据:数据长度为8个字节, 首字节为05H,第二个字节为累加变量,每秒钟数值增加1,-system can address 550 for the test system can, Application T0 1s to every timer can send a bus of data : data length of 8 bytes the first byte of 05H, the second byte of cumulative variable, an increase in value per second.

本库函数为大容量(2M)Flash SST25VF016B的驱动函数 包括IO模拟SPI总线方式和C8051F020硬件SPI方式下的驱动 函数接口简单易用 代码规范简洁-The library functions for large-capacity (2M) Flash SST25VF016B driver function including IO simulation SPI bus mode and SPI mode C8051F020 hardware driver function interface specification concise easy-to-use code

PIC18F4431的电机控制程序,交流马达例程-PIC18F4431 Motor control procedures, exchange of motor routines

USB芯片CH375的库文件，使用库文件可以方便地开发有关USB的项目-USB chip CH375 library files, use the library file you can easily develop a project related to USB

GPS开发 NEA1803 51单片机与12864 由串口中断收取数据 显示经度纬度 高度 速度 时间 使用卫星数-GPS development NEA1803 51 SCM and 12864 collected by the serial interrupt data show a high degree of longitude latitude speed time-use satellite

PCI总线开发 PCI总线开发-Development of PCI bus PCI bus PCI bus development development