good information! Vc and the LabVIEW programming

在纯C语言嵌入式开发环境下可以使用的双链表算法及相关调试接口函数。-double list using C language

应用背景The leading developers of Marlin are currently (January 2015) EvdZ and bkubicek, though many others contribute with their patches. This is a firmware for reprap single-processor electronics setups. It also works on the Ultimaker PCB. It supports printing from SD card+Folders, and look-ahead trajectory planning. This work is licensed under the GNU GPL v3 or (at the user"s discretion) any later version. It is based on Sprinter firmware, which was licensed under GPL v2 or later.关键技术 Features: Interrupt based movement with real linear acceleration. High steprate. Look ahead (Keep the speed high when possible. High cornering speed). Interrupt based temperature protection. preliminary sup

主机为STM32，TMC260的初始化配置，正确配置后才能驱动步进电机，注意CS信号不能缺省

一个中断驱动的具有缓冲区的串口源码(C)-an Interrupt-driven serial port with the source buffer (C)

本文概述了HT1380时钟芯片的特点和基本实例，详细说明了应用软件对HT1380寄存器的功能，详细的位置控制功能请参考泰国HOLTEK公司的相应产品信息

用plc实现了三项异步电机的控制 工业控制中很实用-Plc implementation with three induction motor control is very useful in industrial control

我的课程设计 实现用键盘模拟汽车速度,并在数码管上显示.很简单的.-I realize of course design using keyboard simulation automobile speed, and in digital tube display. Very simple.

keil与proteus联调，含源码、电路-keil with Proteus FBI, including source code, circuit

基于Rfid的考勤系统.it由一个eeprom、rfid传感器、图形显示器、键盘和一个串行端口组成港口。什么时候有人会把卡换掉，时间和日期都会存进去记忆。它可通过串口下载。

点阵单位通常都在任何一个的5x7或8x8的发光二极管矩阵。这些LED连接在矩阵，使得每个LED的阳极或阴极是常见的每一行中。换句话说，在一共阳极LED点阵单元，每个LED行将其所有阳极在该行的有线在一起。 LED的阴极将全部连接在一起在每列中。这样做的原因将很明显很快。一个典型的单一颜色的8x8点阵单位将有16个引脚，8为每个行和8为每一列。的原因的行和列都连接在一起，是尽量减少所需的引线的数量。如果不是这种情况下，一个单一的颜色的8x8点阵单元将需要65管脚，一个用于每个LED和一个共同阳极或阴极连接。通过布线的行和列在一起，只有16个引脚必需的。