uClinux 基于S3C44B0X 键盘驱动

我是做单片机的，请站长和大家多多关照，我上船的这些程度可以作为学习者参考-SCM, please head to take care of you, I embarkation extent of these learners can be used as reference

自动升降电梯控制器设计 要求： 设计一个6层楼的电梯控制器。 该控制器可控制电梯完成6层楼的载客服而且遵循方向优先原则，并能响应提前关门延时关门，并具有超载报警和故障报警； 同时指示电梯运行情况和电梯内外请求信息。-Auto-Lift elevator controller design requirements: design of a six-story elevator controller. The controller can control the completion of six-story elevator containing the principle of giving priority customer service, and follow the directions, and can respond to close ahead of schedule delay closing, and has overload alarm and fault alarm also instructed the elevator and elevator operation request information both inside and outside.

周立功LPC214X关于硬件出发转换的程序.-Ligong LPC214X weeks starting on the hardware conversion process.

本文适用于对嵌入式系统没有概念和经验， 渴望进入嵌入式系统开发的领域， 但又觉得系统太复杂，要学的东西太多， 感觉完全无从学起，无从下手 的 初级开发人员-this applies to the concept of embedded systems and no experience, eager to enter the embedded system development areas, but think the system is too complicated, to learn so many things, not feeling completely started learning the way of the primary developers

fft 变换C程序 不错的-fft transform good C program

频率计是常用的测量仪器，它通过对单位时间内的信号脉冲进行计数，从而测量出信号的频率。设计一个6位频率计，可以测量1～999 999 Hz的信号频率。-Frequency meter is commonly used measuring instruments, which per unit time of the signal pulse count in order to measure the frequency of the signal. 6 to design a frequency counter, can measure 1 ~ 999 999 Hz signal frequency.

资源描述 在KEIL4环境下，实现51系列单片机的C程序开发调试源代码。应用于单片机嵌入是系统。本程序实现51单片机驱动LCD12864，进行汉字显示。

红外遥控逻辑分析器。原代码+电路图 - RAR 压缩文件-Infrared Remote Control logic analyzer. The original code+ Circuit- RAR compressed files

实验室使用的信号收集程序，使用的控制器为TI Cortex- M3，还带有Ad采集，虚拟串口等应用，

单片机设计音乐门铃，仅需at89c51，再加LM386做音频功放，输到扬声器-Single-chip design music doorbell, just at89c51, coupled with the LM386 audio amplifier to do, lose to the speaker